Caterpillar CJ1000DCP Quick Start Guide
This Quick Start Guide is not a substitute for the Instruction Manual. Please refer to the Instruction Manual and your vehicle's user's manual before use.
For questions, contact Customer Service at 1-877-571-2391.
Important Charging Instructions
- Immediately charge this unit for a full 40 hours upon receipt. The unit's internal battery is shipped in a partially charged state and must be fully charged before use.
- Fully charge the unit immediately after purchase, every 30 days, and after each use. Lead-acid batteries can lose charge over time. Regular recharging can optimize performance and battery life.
Unit Overview
Jump Starter: Leave the Safety Switch in the OFF Position (0) while connecting jumper clamps. Activate the switch only after confirming correct polarity.
LCD Screen: The digital display automatically activates and stays on for 10-15 seconds after functions are switched off.
120 PSI Compressor: Press the 'AIR' button to engage compressor mode. Use the arrows to select the desired PSI. Press 'AIR' again to start the automatic compressor.
USB Power: Press the USB button on the control panel once to turn it on/off. Plug your electronic device into any of the USB Ports and operate normally. The LCD Screen will display the Voltage Indicator and USB Power On icon.
LED Light: Press once to turn the built-in work light on/off.
Power Inverter: Press once to turn the AC Outlet on/off.
Battery Status Indicators
Battery Charge Level: Indicates charge from 25% to 100%. Flashes when charging.
Digital Display: Varies by function. Refer to the Instruction Manual for details.
Compressor Pressure Indicator: Shows the current pressure.
USB Power On: Indicates when USB power is active.
Compressor On: Flashes when inflating.
Jump Start Switch On: Indicates the jump start function is active.
Reverse Polarity Indicator: If flashing or buzzing, check clamp connection.
Fault Indicator: Indicates a system fault.
Voltage Indicator: Displays the unit's voltage.
Indicator Icons
| Icon | Solid | Flashing |
|---|---|---|
| ? | Unit is fully charged | Unit is charging |
| ? | USB power is ON | - |
| ⚙️ | Compressor feature has been selected | Compressor feature is ON |
| ? | Vehicle has started | Ready to Jump-start |
| ⚠️ | - | System fault detected* |
| ? | Correct Clamp connection | Reverse Clamp connection |
* Consult the TROUBLESHOOTING section of the Instruction Manual for further information.
Reverse Polarity Alarm
When battery clamps are connected in reverse polarity, an audible alarm (continuous beep) will sound, and the LCD screen will display the Reverse Polarity Indicator icon (refer to Instruction Manual for details). DO NOT activate the jump starter. If this occurs, carefully disconnect the clamps and reconnect with the proper polarity. Ensure that the grounded clamp has a firm and clean connection.
Using the Air Compressor
To prevent overheating, the Air Compressor will automatically shut off after 10 minutes. Please allow a 30-minute cool-down period before resuming inflation. The Air Compressor will store the last PSI setting in memory, making it easier to regularly top off your vehicle's tires.
USB Power
- Press the USB button on the control panel.
- Plug the electronic device into any of the USB Ports and operate normally.
- The LCD Screen will display the Voltage Indicator and the USB Power On icon.
