Singing Machine SML294 Instruction Manual

Included

What's in the box:

• Manual
• USB Charging Cable
• Wireless Dynamic Microphone x2

Rechargeable Battery

This unit features a built-in rechargeable battery pack, allowing operation without AC power. The battery pack is not user-serviceable. For optimal battery life, charge the unit monthly. When the "singing machine" logo flashes red and beeps, charge the unit:

1. Insert the included USB cable into the USB Type-C port on the rear of the unit. Plug the other end into a computer USB port or other USB charging device.
2. Allow approximately 8 hours for a full charge. The "singing machine" logo will turn green when fully charged.
3. Disconnect the USB cable. The fully charged unit provides approximately 4 hours of use, depending on function.

NOTE: The unit cannot be turned on if the battery level is too low. Charging for about 5 minutes is suggested to enable basic functions, but this does not fully charge the battery.

ATTENTION: Sound volume may adjust automatically when the battery is not full.

Recycling and Disposal Information: Do not dispose of electronic devices or components (especially batteries and LCD displays) in municipal trash. Consult local waste management authorities or recycling organizations for proper disposal. Rechargeable batteries must be recycled or disposed of properly.

Printed in China. Model: 294-2304-ENGO2-US

Warnings

CAUTION: RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

[High-voltage warning symbol]: The lightning flash with arrowhead symbol within an equilateral triangle alerts the user to the presence of uninsulated dangerous voltage within the product's enclosure that may constitute a risk of electric shock.

ATTENTION: The exclamation point within an equilateral triangle alerts the user to important operating and maintenance instructions in the accompanying literature.

[Liquid contact warning]: This product shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the product.

[Ventilation warning]: The normal ventilation of the product shall not be impeded for intended use.

Warnings: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications may cause harmful interference unless expressly approved in the manual. Unauthorized changes could void the user's authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with Class B digital device limits, pursuant to part 15 of the FCC Rules. These limits provide reasonable protection against harmful interference in residential installations. If this equipment causes harmful interference to radio or television reception, try correcting it by:

• Reorienting or relocating the receiving antenna.
• Increasing the separation between the equipment and receiver.
• Connecting the equipment to an outlet on a different circuit than the receiver.
• Consulting the dealer or an experienced radio/TV technician.

Rating information is located at the rear of the unit.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

RF Exposure Warning Statements: This equipment complies with FCC radiation exposure limits for an uncontrolled environment. Install and operate with a minimum distance of 20cm between the radiator and body.

Important Safety Information

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install according to manufacturer's instructions.
8. Do not install near heat sources (radiators, heat registers, stoves, amplifiers).
9. Protect the power cord from being walked on or pinched, especially at plugs, receptacles, and where they exit the apparatus.
10. Only use manufacturer-specified attachments/accessories.
11. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When using a cart, exercise caution when moving the cart/apparatus combination to avoid tip-over injuries.
12. Unplug during lightning storms or when unused for long periods.
13. Refer all servicing to qualified personnel. Servicing is required if the apparatus is damaged (power cord, plug), liquid spilled, objects fallen in, exposed to rain or moisture, does not operate normally, or has been dropped.
14. WARNING: To reduce fire or electric shock risk, do not expose to rain or moisture. Do not place liquid-filled objects on the unit.
15. The AC mains plug is the power disconnect device and should remain readily accessible and operable. To completely disconnect power, remove the mains plug from the AC outlet socket.
16. CAUTION: To reduce fire or explosion risk, do not expose batteries to excessive heat (sunshine, fire, etc.).

Troubleshooting Guide

No Power

• Ensure the [power button] is pressed to turn the unit on.
• The unit may have no battery charge. Charge the unit.
• Confirm the USB jack is securely connected to the unit's rear.
• Connect the unit to a different outlet.

NOTE: Product function may be disturbed by strong Electro-Magnetic Interference. Restart the product to resume normal operation. If function does not resume, try using the machine in a different location.

No Sound - General

• Master Volume is set to minimum; raise volume.
• Cable connected to LINE IN jack. When a cable is connected, the Line In function is selected. Unplug to select Bluetooth.
• If using an external device, raise its volume.

No sound from the microphone

• Wireless microphone batteries may be low. Change batteries.
• Ensure the microphone is turned on.
• MIC VOLUME is set to minimum; raise volume.

The Bluetooth device cannot be paired or connected with the unit

• Ensure the Bluetooth function of your device is activated; refer to the device's manual.
• Turn off other Bluetooth devices to avoid accidental pairing.
• The system may not be in pairing mode; press the [Bluetooth button] to restart pairing.

The Music is not available on the unit after successfully connecting the Bluetooth

• Ensure your Bluetooth device supports the A2DP Bluetooth profile.
• The volume on the external Bluetooth device may be low or muted; raise it.
• Ensure your music application is open.

Specifications

AUDIO SECTION

• Output Power (Maximum): 5W (RMS)

BLUETOOTH

• Working Distance: Up to 33 feet/10 meters measured in open space

CONNECTING JACKS

• MICROPHONE: 6.3 mm Microphone Jack (1)
• LINE IN SECTION: 3.5 mm Stereo Jack (1)

GENERAL

• Power: Type-C USB 5VDC, 1A
• Dimension: 11.3 x 8.3 x 5.5 inches / 28.6 x 21 x 13.9 cm
• Weight: 3.7 lbs/1.7 kgs

Wireless Microphone

• Type: 2.4GHz wireless Dynamic Microphone (2)

Making the Connections

BATTERY OPERATION FOR WIRELESS MICROPHONE

To turn on the unit: Press the [power button].

To turn on the wireless microphone: Press and hold the [power button] on the microphone; the light will be solid.

1. Slide the battery door in the direction of the [direction arrow] to reveal the battery compartment.
2. Replace batteries with 2 x "AA" size/LR6 batteries (not included). Ensure correct polarity ([positive terminal] and [negative terminal]).
3. Replace cover tightly before operating.

NOTES:

• Working distance of up to 66 feet/20 meters in open space.
• If there is no audio input for 20 minutes, the wireless mic connection will automatically turn off. Press the [power button] to reactivate the connection.
• When wireless microphone batteries are low, the battery indicator will flash. Change batteries as described above.

CAUTION: Replace all batteries at the same time. Do not mix old batteries with new batteries.

Battery Precautions:

• Use only specified battery size and type.
• Follow correct polarity when installing batteries. Reversed batteries may cause damage.
• Do not mix battery types (e.g., Alkaline and Carbon Zinc) or old with fresh ones.
• Remove batteries if the device is not used for a long period to prevent damage or leakage.
• Do not try to recharge non-rechargeable batteries; they can overheat and rupture.
• Rechargeable batteries are to be removed before charging and charged under adult supervision.
• Exhausted batteries must be removed from the product.
• Batteries shall not be exposed to excessive heat (sunshine, fire, etc.).

Diagram Description: The diagram shows a wireless microphone with battery compartment access and battery orientation indicators.

Connect the wired microphone (not included) into Mic jack 1 (when desired).

NOTE: Maximum of three microphones (wired or wireless) can be connected at one time.

Connect the external unit to the AUX IN jack 2 on the back of this unit. When connected, the Aux In function is automatically selected. You can also record and playback your singing and the music (see "Operation points 6 & 7").

NOTES:

• It is highly recommended to set the volume on the external unit to 1/3 or lower to avoid distortion.
• Skipping tracks is not possible from this unit when using an external device.

Diagram Description: The diagram shows the rear of the unit with Mic jack 1, AUX IN jack 2, and USB Type-C port 3.

CONNECTING TO POWER

Insert the USB cable (included) into USB Type-C port 3 on the rear of the unit. Plug the other end into a computer USB port or other USB charging device (not included).

NOTE: If the unit is unresponsive while mounted, use a pin to press the reset button located inside the AUX IN jack.

Energy Saving Mode (Auto Power System-APS)

This unit will automatically turn off after 20 minutes of inactivity. To resume use, press the [power button]. APS is for energy saving purposes.

Operation

1. Press the [power button] to turn the unit on. Light mode 1 is activated, with lights synchronizing to sound. Press the [power button] again for Light mode 2 (lights only, no sound response). Press the [power button] once more to turn off the lights. Press and hold the [power button] to turn the unit off.
2. Press the [voice effect button] or [voice effect button] to select vocal effects. The [mic guy icon] light changes: Pink [female icon], Orange [male icon], Cyan [robot icon], Blue [radio icon], Purple [echo icon], Lime [chipmunk icon]. Select white [none icon] for no effect.
3. Press the [volume down button] or [volume up button] to adjust the volume of both microphones.
4. When the unit is on and no cable is connected to AUX IN, it automatically searches for and pairs with a previously paired Bluetooth device. If none are present, press the [Bluetooth button] to disconnect any paired devices to pair another.
5. Turn on your device's Bluetooth option to search for a discoverable device. Select "SINGING MACHINE" from the device results.

   NOTES:

   • Refer to your Bluetooth device's user manual for detailed instructions.
   • If a passcode is required, enter "0000".
   • On some devices, after pairing, select "Use as Audio Device" or similar.
   • If connection is lost, ensure the distance between the speaker and Bluetooth device does not exceed 30 feet/10 meters.

   The light will turn solid and a chime will sound indicating successful pairing.

   Diagram Description: The diagram shows the control panel with buttons for power, light modes, voice effects, volume, track control, record, and playback.

6. Press the [vocals off button] to remove the lead singer from a recording. Press again to restore the lead singer. NOTE: Vocal off function effectiveness is song-dependent.
7. During music playback, press the [record button] to record your singing and music; the [mic guy icon] will flash red. Press [record button] again to stop recording; the red light turns off. The unit records for up to 260 seconds. Recording stops automatically. NOTES: Each new recording overwrites the previous one. Do not record with minimum volume.
8. To playback your voice recording, press the [playback button]; the [mic guy icon] will turn solid red. Press again to stop. Press and hold to clear the recording.
9. To control your Bluetooth device, press the [play button] to start playback (music app must be open). Press the [pause button] during playback to pause. Press the [next track button] or [previous track button] to advance or go back one track.
10. Adjust volume using the [volume down button] or [volume up button] on the unit, and the volume on your Bluetooth device.

Bluetooth® word mark and logos are registered trademarks of Bluetooth SIG, Inc. Use by The Singing Machine Company, Inc. is under license. Other trademarks and trade names belong to their respective owners.

The Responsible Party:

Company Name: The Singing Machine Company, Inc.

Address: 6301 NW 5th Way, Suite 2900, Fort Lauderdale, FL33309, USA

Telephone: 1-866-670-6888

Website: www.singingmachine.com