Samsung VS15A60 Vacuum Cleaner User Manual

Key Components and Accessories

Main Unit Components:

• Power button
• Handle
• Suction power control button
• Battery level indicator
• Dustbin release button
• Fine dust filter
• Dustbin
• Pipe
• Battery release button
• Battery

Dustbin and Filter:

• Washable micro filter
• Metal mesh grille filter
• Dustbin

Wall Mount Components:

• Vacuum charging part
• Accessory holder
• Battery charger

Included Accessories (may vary):

• Battery charger
• Pipe
• Battery
• Extension Crevice Tool
• Wall mount (includes screws/anchors)
• Jet Fit Brush
• Combination Tool
• Mini Motorized Tool

Battery Specification:

VS15A60**** Series: Lithium-ion 21.6 V, 1800 mAh, 6 cell

Installation

Wall Mount Installation:

The top of the wall mount should be installed 113 cm from the floor.

CAUTION:

• Install the wall mount on a hard concrete wall.
• If installing into drywall without a stud, use the provided drywall anchors.

NOTE:

Refer to online resources for detailed installation information.

Operation

Charging the Battery:

• Charge the battery when the battery level indicator blinks at its lowest level.
• Ensure the connection part of the wall mount is correctly connected when charging.
• The vacuum cleaner cannot be used while charging.
• Using the Wall Mount: Ensure the battery is correctly placed on the charging part. The battery level indicator should display while charging and blink during charging. It stops blinking and dims when fully charged.
• Using a Desk Charger: Push the battery firmly into the desk charger. Check the battery level indicator.

CAUTION:

• Turn the product off before ejecting the battery. Ejecting it while operating may cause malfunction.
• Handle the battery carefully to avoid dropping it, which could cause injury or damage.

Ejecting and Re-inserting the Battery:

• Press the battery release button at the rear of the handle to eject the battery.
• Insert the battery until you hear a "click" to ensure it is firmly attached.

Storing Accessories:

• Dust may fall from the suction part when accessories are disassembled.
• After cleaning, operate in MAX mode for 10 seconds to clear foreign matter.
• Assemble accessories to the holders as shown in diagrams. Folding accessory holders is easier if the Extension Crevice Tool is inserted first.

Operating the Vacuum Cleaner:

• Power Button (A): Press to start operation in 'MID' mode.
• Suction Power Control Button (B): Use the [+] button to increase and the [-] button to decrease suction power.

Disassembling Accessories:

• To detach the pipe, press the release button at the rear of the pipe.
• To detach the brush, press the release button at the rear of the brush.
• Operate in MAX mode for over 10 seconds before disassembling to remove residual foreign matter.

Accessory Usage:

• Jet Fit Brush: For cleaning various floor types, including carpets.
• Mini Motorized Tool: For cleaning bedding.
• Combination Tool: For removing dust from curtains, furniture, and sofas.
• Extension Crevice Tool: For cleaning grooves, window frames, and corners.

Maintenance

CAUTION:

• Turn the vacuum cleaner off before cleaning.
• If the dustbin or filter is full, the vacuum may stop due to the overheating prevention device. Clean the dustbin or filter before it becomes completely full (indicated by the MAX sign).

Emptying and Cleaning the Dustbin:

• Remove dust from the metal mesh grille filter using the Combination Tool. Do not pull the rubber attached to the filter.
• Clean and dry the dustbin in the shade after emptying. Avoid applying heat, as it may cause product malformation.

Cleaning Filters:

• Washable Micro Filter: Remove dust frequently. Wash with water once a month. Dry completely in the shade for over 24 hours before use. Avoid applying heat.
• Fine Dust Filter: Remove dust frequently. Wash with water once a month. Dry completely in the shade for over 24 hours before use. Avoid applying heat.

NOTE:

When assembling filters, ensure the line below the lock image is not visible.

Cleaning Specific Tools:

• Mini Motorized Tool
• Extension Crevice Tool / Pipe
• Jet Fit Brush: If foreign matter is stuck, use scissors to remove it. If the brush stops due to tangled foreign matter (cloth, hair), turn the vacuum off and on again. If a brush is not working, turn off and on again. Be careful not to catch fingers in the brush folds during cleaning.

NOTE:

Sometimes brush wheels can scratch floors. Check wheels before use. Contact service if foreign matter on wheels cannot be removed.

CAUTION:

• Storing the vacuum in direct sunlight for extended periods may cause deformation or discoloration. Dry parts in the shade after cleaning.
• Do not clean the brush with water, as it can cause deformation or discoloration.
• Unplug the wall mount before cleaning it.
• If suction is continuously reduced or the vacuum overheats, replace the fine dust filter.
• After cleaning washable parts with water, dry them in the shade. Avoid applying heat.

Safety Information

Read this manual thoroughly and retain it for reference before operating the appliance. Note that characteristics may differ slightly from descriptions.

WARNING Symbols:

• Indicates danger of death or serious injury.

CAUTION Symbols:

• Indicates risk of personal injury or material damage.

NOTE Symbols:

• Indicates additional important information.

Failure to follow these instructions may damage internal parts and void the warranty.

General Safety:

• Read all instructions carefully.
• Ensure your electricity supply voltage matches the rating plate.
• Do not use on wet rugs or floors.
• Close supervision is required when used by or near children. Do not allow children to use it as a toy or unattended. Use only for its intended purpose.
• Do not use without a dustbin.
• Empty the dustbin before it is full for maximum efficiency.
• Do not pick up matches, live ashes, or cigarette butts. Keep away from heat sources.
• Avoid picking up hard or sharp objects.
• Do not block suction or exhaust ports.
• Grasp the plug, not the cord, to remove it from the outlet.
• This appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience, unless supervised.

Wall Mount and Battery Safety:

• Do not bend the battery charger excessively or place heavy objects on it.
• Keep power plug contacts clean and dry.
• Do not pull the cord or touch the plug with wet hands.
• Use the correct voltage; do not use multi-plugs or power strips. Keep cords near walls.
• Do not use damaged plugs, chargers, or outlets.
• Have damaged chargers replaced by an authorized Samsung service center.
• Do not touch charging terminals with metal objects.
• Ensure battery terminals do not contact conductors (bracelets, watches, etc.).
• Prevent liquids from entering the vacuum cleaner or wall mount.
• Do not use the wall mount for purposes other than intended.
• Do not vacuum liquids, blades, pins, or embers.
• Do not step on or strike the product.
• Do not block the brush or air outlet during cleaning to prevent overheating.
• This product is for household use only. Do not use for heavy-duty, commercial, industrial, or outdoor cleaning.
• Avoid using near heating appliances or combustible sprays/materials.
• Ensure filters are correctly inserted.
• In case of gas leaks or combustible sprays, ventilate the area.
• If the vacuum makes strange sounds, smells, or emits smoke, turn it off immediately and contact a Samsung service center.
• Do not use near combustible materials (candles, heaters, flammable liquids, etc.).
• Do not allow children to cling to or push the wall mount.
• Store the vacuum on the floor for short periods during cleaning.
• Do not charge near windows, heaters, or bathrooms.
• Store the vacuum in the wall mount or safely on the floor.
• Do not lean the vacuum against a wall or table.
• Do not use the vacuum for purposes other than intended (e.g., children riding).
• Before plugging/unplugging, turn off the vacuum and avoid touching pins.
• Be careful of moving/spinning parts. Do not suction body parts.
• Use both hands when cleaning walls/ceilings or vacuuming.
• Be careful of fingers during assembly.
• Do not use on easily scratched objects.
• Do not store in a car.
• Do not use water to clean the vacuum while it is in use.
• Use only in dry places.
• Do not use in wet places or on water.
• Do not pick up spilled beverages or pet waste.
• Do not use in direct sunlight or high heat.

Battery Safety:

• Do not disassemble the battery or wall mount.
• Do not apply heat to the battery or put it in fire.
• Use the battery only for this product.
• Do not drop or strike the battery.
• Do not create short circuits across battery terminals.
• If battery liquid leaks, wash affected skin with water or flush eyes with clean water and seek medical attention.
• The vacuum may not operate if the temperature is below 5°C or above 45°C to protect the motor and battery.

Troubleshooting

Common Problems and Solutions:

• Vacuum cleaner does not work: Check battery level/charge, ensure it's on, check for blockages (pipe, dustbin, brush), verify filter insertion, charge if unused, replace battery if dead.
• Suction force decreases suddenly / vibrating sound: Check for clogged brush, dustbin, or pipe; remove foreign matter. Check if dustbin is full and empty it. Clean dirty filters.
• Vacuum cleaner cannot be charged: Check charging terminal for foreign matter (clean with cotton swab/soft cloth). Ensure vacuum is on and battery LED indicator is lit.
• Spinning brush (drum) does not work: If brush is stuck, turn off vacuum, check for foreign matter, remove it, and restart. Turn vacuum off and on again. For Jet Fit Brush, allow 30 minutes to cool if overheated.
• Odor from air outlet or filter: Empty dustbin and clean filters frequently. New products may have a slight odor for the first 3 months. Accumulated dirt can cause odor. Replacement filters are available.
• Small dust particles come out of brush after cleaning: Operate vacuum for 10 seconds to suction up remaining particles.
• Vacuum cleaner stops operation during cleaning: This is due to the overheating prevention device. It may occur if the dustbin is full, a part is clogged, or the Extension Crevice Tool is used for extended periods. Correct the cause and turn the product on again.
• Static electricity occurs when cleaning a thick and soft mat: Mat material can cause static electricity. Move the brush on a normal floor for a while and clean again.

Product Specifications

Note: Charging and cleaning times may differ depending on the brushes and conditions of use.

Contact Information

For questions or comments regarding Samsung products, please contact the SAMSUNG customer care center.

This product is RoHS compliant.