Mikrotikls SIA C52-5AXD2AXD hAP ax2 TV7C52-5AXD2AXD TV7C525AXD2AXD c52 5axd2axd
MRT Technology (Suzhou) Co., Ltd Phone: +86-512-66308358 Web: www.mrt-cert.com Report No.: 2212RSU016-U2 Report Version: V01 Issue Date: 2023-01-09 RF Exposure Evaluation Declaration FCC ID: TV7C52-5AXD2AXD Applicant: Mikrotikls SIA Product: hAP ax2 Model No.: C52iG-5HaxD2HaxD-TC-US Brand Name: MikroTik FCC Classification: Digital Transmission System (DTS) Unlicensed National Information Infrastructure (NII) FCC Rule Part(s) FCC Part 2.1091 Test Procedure Result: KDB 447498 D04 Interim General RF Exposure Guidance v01 Complies Reviewed By: Approved By: Vincent Yu Robin Wu The test results relate only to the samples tested. The test results shown in the test report are traceable to the national/international standards through the calibration of the equipment and evaluated measurement uncertainty herein. The test report shall not be reproduced except in full without the written approval of MRT Technology (Suzhou) Co., Ltd. Template Version:0.0 1 of 8 Report No. 2212RSU016-U2 Version Rev. 01 Revision History Description Initial Report Report No.: 2212RSU016-U2 Issue Date 2023-01-09 Note Valid 2 of 8 Report No.: 2212RSU016-U2 CONTENTS Description Page 1. General Information ................................................................................................................................ 4 1.1. Applicant........................................................................................................................................ 4 1.2. Manufacturer ................................................................................................................................. 4 1.3. Testing Facility............................................................................................................................... 4 1.4. Product Information ....................................................................................................................... 5 1.5. Antenna Details ............................................................................................................................. 5 1.6. Device Classification ..................................................................................................................... 6 2. RF Exposure Evaluation......................................................................................................................... 7 2.1. Test Limits ..................................................................................................................................... 7 2.2. Test Result..................................................................................................................................... 8 3 of 8 1. General Information 1.1. Applicant Mikrotikls SIA Brivibas gatve 214i, Riga, LV-1039 LATVIA Report No.: 2212RSU016-U2 1.2. Manufacturer Mikrotikls SIA Brivibas gatve 214i, Riga, LV-1039 LATVIA 1.3. Testing Facility Test Site MRT Suzhou Laboratory Laboratory Location (Suzhou - Wuzhong) D8 Building, No.2 Tian'edang Rd., Wuzhong Economic Development Zone, Suzhou, China Laboratory Location (Suzhou - SIP) 4b Building, Liando U Valley, No.200 Xingpu Rd., Shengpu Town, Suzhou Industrial Park, China Laboratory Accreditations A2LA: 3628.01 CNAS: L10551 FCC: CN1166 ISED: CN0001 VCCI: R-20025 R-20141 G-20034 G-20134 C-20020 C-20103 T-20020 T-20104 Test Site MRT Shenzhen Laboratory Laboratory Location (Shenzhen) 1G, Building A, Junxiangda Building, Zhongshanyuan Road West, Nanshan District, Shenzhen, China Laboratory Accreditations A2LA: 3628.02 CNAS: L10551 FCC: CN1284 ISED: CN0105 Test Site MRT Taiwan Laboratory Laboratory Location (Taiwan) No. 38, Fuxing 2nd Rd., Guishan Dist., Taoyuan City 333, Taiwan (R.O.C.) Laboratory Accreditations TAF: L3261-190725 FCC: 291082, TW3261 ISED: TW3261 4 of 8 Report No.: 2212RSU016-U2 1.4. Product Information Product Name hAP ax2 Model No. C52iG-5HaxD2HaxD-TC-US Wi-Fi Specification 802.11a/b/g/n/ac/ax, VHT Hardware Version r3 Software Version RouterOS v7 Antenna Information Refer to section 1.5 Working Voltage Range 12~28VDC (24VDC Nominal) Working Temperature 0 ~ 50°C Accessory Adapter Model: SAW30-240-1200U A Input: 100-240V ~ 50//60Hz 0.8A Output: 24.0V 1200mA Remark: The information of EUT was provided by the manufacturer, and the accuracy of the information shall be the responsibility of the manufacturer. 1.5. Antenna Details Antenna Type Frequency Band (MHz) Wi-Fi Antenna (2*2 MIMO) Max Peak Gain (dBi) CDD Directional Gain (dBi) For Power For PSD 2.400 ~ 2483.5 5.50 5.50 8.51 5150 ~ 5250 3.20 3.20 6.21 5250 ~ 5350 4.20 PCB Antenna 5470 ~ 5725 5.20 4.20 7.21 5.20 8.21 5725 ~ 5850 5.00 5.00 8.01 5850 ~ 5895 4.70 4.70 7.71 Note: The EUT supports Cyclic Delay Diversity (CDD) mode, and CDD signals are correlated. For CDD transmissions, directional gain is calculated as follows, NANT = 2, NSS = 1. If all antennas have the same gain, GANT, Directional gain = GANT + Array Gain, where Array Gain is as follows. · For power spectral density (PSD) measurements on all devices, Array Gain = 10 log (NANT/ NSS) dB = 3.01; · For power measurements on IEEE 802.11 devices, Array Gain = 0 dB for NANT 4; 5 of 8 Report No.: 2212RSU016-U2 1.6. Device Classification According to the user manual, the antenna of this device is at least 38 cm away from the body of the user, this device is classified as a Mobile Device. So, the RF exposure evaluation requirements of § 2.1091 for mobile device exposure conditions subject to MPE limits. 6 of 8 Report No.: 2212RSU016-U2 2. RF Exposure Evaluation 2.1. Test Limits According to FCC Part 2.1091, A mobile device is defined as a transmitting device designed to be used in other than fixed locations and to generally be used in such a way that a separation distance of at least 20 cm is normally maintained between the RF source's radiating structure(s) and the body of the user or nearby persons. According to FCC Part 1.1307(b)(3)(i)(C), for the exemption in Table 1 to apply, R must be at least /2, where is the free-space operating wavelength in meters. If the ERP of a single RF source is not easily obtained, then the available maximum time-averaged power may be used in lieu of ERP if the physical dimensions of the radiating structure(s) do not exceed the electrical length of /4 or if the antenna gain is less than that of a half-wave dipole. Table 1 to § 1.1307(b)(3)(i)(C) - Single RF Sources Subject to Routine Environmental Evaluation RF Source Frequency (MHz) 0.3-1.34 1.34-30 30-300 300-1500 1500-100,000 Threshold ERP (watts) 1.920 R2 3.450 R2/f2 3.83 R2 0.0128 R2f 19.2 R2 f = frequency in MHz, R = minimum separation distance in meters. According to FCC Part 1.1307(b)(3)(ii)(B), in the case of fixed RF sources operating in the same time-averaging period, or of multiple mobile or portable RF sources within a device operating in the same time averaging period, if the sum of the fractional contributions to the applicable thresholds is less than or equal to 1 as indicated in the following equation. 7 of 8 Report No.: 2212RSU016-U2 2.2. Test Result Product Test Item hAP ax2 RF Exposure Evaluation Test Mode Frequency Max. Max. Max. EIRP Compliance Band Conducted Antenna (dBm) Distance (R) (MHz) Power Gain (m) (dBm) (dBi) 802.11b/g/n/ax, VHT 2412 ~ 2462 29.31 5.50 34.81 0.38 5180 ~ 5240 28.48 3.20 31.68 0.38 5260 ~ 5320 23.78 4.20 27.98 0.38 802.11a/n/ac/ax 5500 ~ 5720 23.88 5.20 29.08 0.38 5745 ~ 5825 26.51 5.00 31.51 0.38 5845 ~ 5885 26.92 4.70 31.62 0.38 Note: 1. EIRP (dBm) = Max. Conducted Power (dBm) + Max. Antenna Gain (dBi) 2. ERP (W) = 10[ERP (dBm) 30)]/10 = 10[EIRP (dBm) - 2.15 (dB) - 30]/10 3. Threshold ERP (W) = 19.2 * R2 (W) = 19.2 * 0.382 (W) = 2.772 (W) ERP (W) 1.8450 0.8974 0.3828 0.4932 0.8630 0.8851 Threshold ERP (W) 2.772 2.772 2.772 2.772 2.772 2.772 The 2.4GHz WLAN and 5GHz WLAN can transmit simultaneously. Exposure Ratio = 1.8450 / 2.772 + 0.8974 / 2.772 = 0.9892 < 1. Therefore, this device meets the RF Exposure requirements when it is installed and operated with a minimum distance of 38cm between the radiator and user. The End 8 of 8福昕高级PDF编辑器打印机版本10.1.0.3521