Broyhill® SINCE 1905

GENERAL BEST PRACTICES FOR ASSEMBLY:

• Please read and understand this entire manual before attempting to assemble or install the product.
• Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
• Do not place the product on a damp or conductive subsurface.

WARNINGS:

• The manufacturer does not accept any responsibility for injuries or damage resulting from improper use of the product. If in doubt, consult a qualified electrician.
• Do not mix old and new batteries. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel - Cadmium) batteries. If any noise, excessive temperature or leakage from a battery is found, please discard. When not using the unit for a considerable period of time, disconnect the batteries from the unit for storage. If battery power is weak during use, switch off the device and dispose of batteries.
• Do not dispose of batteries in fire, as batteries may explode or leak.
• This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
• Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

WARRANTY:

WHAT IS COVERED?

The limited warranty is extended to the original purchaser and applies to material and manufacturer's defect provided the item is maintained with care and used only for personal, residential purposes.

Warranty: 6 months

MAINTENANCE:

• Place 3 AA batteries into the battery case. Batteries not included.
• Maintenance/cleaning of the lights is limited to the surface exterior, using a dry cloth only.
• Steel components for this table are treated with rust inhibiting paint that protects it from rusting. However, due to the nature of steel, surface oxidation (rusting) will occur if these protective coatings are scratched. This is not a defect and thus not covered by the warranty.

Responsible Party - U.S. Contact Information

EXPLODED DRAWING

This section illustrates the main components of the Penner Chandelier:

• A: Chain - Used for hanging the chandelier.
• B: Lamp Body - The main decorative frame of the chandelier, featuring a woven wood design.
• C: Bulbs - Four light bulbs that fit into the lamp body.
• D: Remote Control - A handheld device with power and brightness buttons to operate the chandelier.

PARTS LIST

How many people are needed for the installation

One person is needed for the installation.

STEP 1

Attach the Lamp Body to the Chain

Hook the lamp body (B) onto the chain (A) by connecting the four attachment points on the lamp body to the chain in the specified order (1, 2, 3, 4). Ensure the lamp body is securely fastened to the chain.

Assembled View: The lamp body hangs suspended from the chain, ready for bulb installation.

STEP 2

Install Bulbs and Prepare Remote Control

Insert the four bulbs (C) into the designated sockets within the lamp body (B). Ensure they are securely screwed in. The remote control (D) is provided for operating the chandelier's lighting functions.

Assembled View: The chandelier is fully assembled with bulbs installed and the remote control ready for use.