Drift DR50 Gaming Chair Assembly Instructions

Parts Included

• Seat mounting bracket/mechanism (1x)
• Seat base (1x)
• Left armrest (1x)
• Right armrest (1x)
• Gas lift (1x)
• Telescopic gas lift cover (1x)
• Chair base (star-shaped) (1x)
• Wheels (5x)
• Washers (4x)
• Screws (4x)
• Screws (8x)
• Screws (8x)
• Allen wrench (1x)
• Decorative cover for gas lift housing (1x)

Step 1: Attach Seat Mechanism

Attach the seat mounting bracket/mechanism to the underside of the seat base using 4 screws and 4 washers. Ensure all fasteners are tightened securely.

Step 2: Attach Armrests

Attach the left and right armrests to the sides of the seat base. Use 4 screws for each armrest, totaling 8 screws. Tighten securely.

Step 3: Assemble Chair Base

Insert the 5 wheels into the sockets at the end of each leg of the star-shaped chair base. Push firmly until they are fully seated.

Step 4: Install Gas Lift

Place the gas lift into the center hole of the chair base. Then, slide the telescopic gas lift cover over the gas lift cylinder.

Step 5: Connect Seat to Base

Align the seat mounting bracket (attached to the seat base) with the top of the gas lift. Carefully lower the seat assembly onto the gas lift. The chair's weight will secure it.

Step 6: Final Touches

Attach the decorative cover for the gas lift housing to the appropriate location on the chair.