Anko 10" RGB Ring Light with Remote Control - Instruction Manual

Product Overview

This document provides instructions for the Anko 10" RGB Ring Light with Remote Control. It details the product's components, specifications, operation via in-line controls and remote, installation steps, and important safety warnings.

Included Components:

• 10" RGB ring light
• Remote control
• Universal smart phone holder
• Tripod stand
• 360° ball head mounting bracket

Specifications

• Model No: 43115044
• Power: 10W
• Colours: 13 RGB solid colours + 3 white colours
• Power Supply Mode: USB 5V/2A
• Product Size: 26cm x 185cm

In-line Control Operation

The ring light features an in-line control unit with the following functions:

• [ON/OFF & RGB Button]: Press once to turn the light on or off, and to cycle through RGB light modes.
• [UP Button]: Press once to increase the light brightness by one level.
• [DOWN Button]: Press once to decrease the light brightness by one level.
• [ON/OFF & LED Button]: Press once to turn the light on or off, and to cycle through Warm white, Natural white, and Cool white light modes.

Visual Description: The in-line control unit is depicted with an infrared receiver and a power indicator light, alongside the four operational buttons.

Remote Control Operation

The remote control requires 2x AAA batteries, which are not included.

• [OFF Button]: Press once to turn the light off.
• [ON Button]: Press once to turn the light on.
• [UP Button]: Press once to increase the light brightness by one level.
• [DOWN Button]: Press once to decrease the light brightness by one level.
• [Red Light Button]: Press once to change the light to Red.
• [Green Light Button]: Press once to change the light to Green.
• [Blue Light Button]: Press once to change the light to Blue.
• [White Light Button]: Press once to cycle through Natural white, Warm white, and Cool white light modes.
• [RGB Colour Buttons]: Press these buttons to select from 12 different RGB solid colours.
• [FLASH Mode Button]: Press once to activate flash mode.
• [STROBE Mode Button]: Press once to activate strobe mode.
• [FADE Mode Button]: Press once to activate fade mode.
• [SMOOTH Mode Button]: Press once to activate smooth mode.

Visual Description: The remote control diagram shows numbered buttons corresponding to the operations listed above. A separate diagram illustrates the battery compartment for 2x AAA batteries.

Installation Method

Step 1: Setting up the Tripod Stand

1. Remove the tripod stand (labelled ⑥ in diagrams) from the packaging.
2. Pull out the tripod's feet to extend them.
3. Adjust the tripod height by turning the fixed handle clockwise to secure it. (Refer to [Diagram 1] for visual guidance on tripod assembly).

Step 2: Attaching the Ring Light and Phone Holder

1. Take the ring light (labelled ② in diagrams) and the universal smart phone holder (labelled ④ in diagrams) from the box.
2. Turn the phone holder ④ clockwise onto the top of the tripod stand ⑥.
3. Secure the ring light ② onto the phone holder ④ by screwing it into place. (Refer to [Diagram 2] for visual guidance on attaching components).

Visual Description: [Diagram 1] illustrates the tripod stand with its feet extended and a fixed handle for height adjustment. [Diagram 2] shows the ring light and phone holder attached to the top of the assembled tripod.

Warnings

• Only qualified service technicians or authorized service agents should attempt to repair this product.
• The light source within this unit can only be replaced by the manufacturer, its service agent, or a similarly qualified person.
• The external flexible cable or cord of this light cannot be replaced. If the cord is damaged, the light should not be used.