Important Safety Information
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device should be connected to a properly grounded outlet. Refer to the grounding instructions.
This device is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the device by a person responsible for their safety. Children under 13 years of age should be prevented from accessing this device.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not alter the plug in any way.
⚠ DANGER - To reduce the risk of electric shock:
- Always unplug the appliance from the electrical outlet immediately after using and before cleaning.
⚠ WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons:
- An appliance should never be left unattended when plugged in. Unplug from outlet when not in use, and before putting on or taking off parts.
- Close supervision is necessary when this appliance is used by or near children, invalids, or disabled persons.
- Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to a service center for examination and repair.
- Do not carry this appliance by supply cord or use cord as a handle.
- Keep the supply cord away from heated surfaces.
- Never drop or insert any object into any opening.
- Do not use outdoors.
- Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
- To disconnect, turn all controls to the off position, then remove plug from outlet.
Table of Contents
1.1 Product and Accessories
Welcome!
Thank you for choosing the KingSmith WalkingPad treadmill. It features a simple, exquisite, and innovative design. Users can enjoy home workouts and improve their quality of life. The treadmill is intended for home use only, not for commercial purposes, rental, or public organizations.
Product Specifications
| Operating Indicator | Detailed Parameters |
|---|---|
| Suitable Age | 14-60 years |
| Speed Range | 1-12km/h |
| Running Area | 460x1210 mm |
| Maximum Load | 110 kg |
| Frequency | 50/60 Hz |
| Voltage | 100-127V |
| Power | 918W |
| Net Weight | 37 kg |
| Unfolded Dimensions | 1419x711x1053 mm |
| Folded Dimensions | 1007x711x225 mm |
Accessories
Carefully check if the items in the package box are complete and undamaged. If any items are missing or damaged, contact the seller.
The package includes the KingSmith WalkingPad Treadmill unit, a power cable, a mobile phone holder, a safety key, a wrench, silicone oil, and this user manual.
1.2 Functional Diagram
1. Unfolded Treadmill
The unfolded treadmill features a mobile phone holder at the top, a control knob and display panel below it, and a safety key socket in the center. The main body includes a handrail and a running belt. The base has foot supports.
2. Folded Treadmill
In its folded state, the treadmill is compact. It shows the screw for attaching the mobile phone holder, the power socket, and the power switch. Wheels are visible at the base for easy movement.
3. Display Panel Functions
The display panel shows various metrics during operation:
- TIME: Displays the duration of your workout.
- SPEED: Shows the current speed of the running belt.
- DISTANCE: Indicates the distance covered.
- CALORIES: Displays the estimated calories burned.
- NFC Area: A designated area for NFC functionality.
The central control knob allows for interaction with the display and speed adjustment.
1.3 Instructions for Initial Use
- Preparation for Movement: Before pushing or pulling the treadmill, ensure it is locked and placed on a flat surface.
- Unfolding the Treadmill: Pull up the locking lever of the treadmill to unlock it, then slowly unfold it until it is flat.
- Adjusting the Running Belt: Unfold the treadmill, adjust the running belt to the center position, slowly unfold and press the treadmill or turn the bottom foot pad until it is completely flat.
- Attaching the Mobile Phone Holder: Take the mobile phone holder from the accessory box, align the two large holes with the fixing screws under the holder, then push in the direction of the narrow ends of the holes to secure the mobile phone holder to the pole.
- Inserting the Safety Key: Take the safety key from the accessory box and insert it into the safety key socket in the middle of the handrail.
- Connecting Power: After connecting the power cable, turn on the treadmill switch.
- Installing the KS Fit App: Scan the QR code provided or search for 'KS Fit' in the App Store or Google Play to complete the installation and log in.
- Connecting to the App: Before using the treadmill, open the APP, add and connect the treadmill according to the instructions.
1.4 Operation Instructions
1. Starting to Run
Upon powering on the treadmill, the display panel will show all parameters as '0' by default.
2. Safety Key
If the safety key is not inserted, the display will show 'Safety' and activate 'SAFE' mode. To start the treadmill, insert the safety key.
3. Short Press to Start
In default mode, short press the control knob for 3 seconds, and the treadmill will slowly start.
4. Speed Adjustment
To accelerate, rotate the control knob clockwise. To decelerate, rotate the control knob counter-clockwise.
5. Quick Speed Regulation
Rotate the control knob quickly to switch between speed levels: 1 km/h, 3 km/h, 6 km/h, 9 km/h, and 12 km/h.
6. Pause/Standby
When the control knob is short-pressed during operation, or if the treadmill runs without load for 5 minutes, it will slowly stop and enter standby mode. Short press the Spin Controller again to restart the treadmill, which will return to its previous speed level before standby.
7. Pause Mode
In pause mode, the treadmill stops when the control knob is pressed for 2 seconds or if it is inactive for 180 seconds, and all parameters will return to '0' by default.
8. Power Off
After finishing your workout, turn off the switch and unplug the power cable.
2. Other States Displayed on the Control Knob Screen
The Spin Controller screen also displays specific states:
- Lock: Indicates the treadmill is locked.
- Safety: Indicates the safety key is not inserted or an issue related to safety.
- Upgrade: Indicates a software upgrade is in progress.
- E06: Indicates an error (specific error codes are detailed below).
As the treadmill system is continuously upgraded and optimized, some operations may be adjusted. Please refer to the actual treadmill features during use.
3. Standby and Wake-up
If the control knob is long-pressed for 3 seconds in standby mode (all parameters displayed as 'O') or if the treadmill is not moved for 5 minutes, it will enter standby mode and the panel lights will turn off. In standby mode, short press the control knob to wake up the treadmill.
4. Error Codes
- E01: Program overcurrent
- E02: Hardware overcurrent
- E03: IPM module overheating
- E04: Undervoltage protection
- E05: Overvoltage protection
- E06: Motor open phase protection
- E07: Motor rotor lock protection
- E08: Sensor error
- E09: Motor start failure
- E12: Overcurrent protection
- E13: Overload protection
- E14: Hall signal loss
- E15: Communication error
1.5 Trademark and Legal Statement
Various patents related to the KingSmith WalkingPad Treadmill series are developed and copyrighted by Beijing KingSmith Technology Co., Ltd. (referred to as "KingSmith"). Without written permission from KingSmith, no organization or individual may copy or distribute all or any part of this user manual, nor use the patents contained herein.
This user manual includes the latest functional presentations and usage instructions available at the time of printing. However, due to continuous optimization of functions and models, there may be differences between the purchased treadmill and those described in this manual. In case of any discrepancies in color and appearance, the actual treadmill prevails.
1.6 Safety Precautions
⚠ When using the treadmill, wear sports shoes and clothing, and exercise appropriately according to your health condition. If you feel uncomfortable during exercise, stop immediately and consult a doctor to avoid potential injury.
⚠ Before using the treadmill, please securely attach the safety key to your clothing at the other end. In case of emergency, pull the safety key to stop the treadmill immediately.
⚠ If you need to jump off the treadmill in an emergency, hold the handrails with both hands to support your body. Therefore, there must be a distance of at least 2.5 meters or more behind the treadmill.
⚠ The distance between the treadmill and other objects on both sides must be at least this much.
⚠ Strictly prohibit using the treadmill on uneven ground.
⚠ When the treadmill is not in use, unplug the power cable.
⚠ Do not use the treadmill in the presence of pets.
⚠ Do not use the treadmill backwards or facing away.
⚠ Elderly, children, and pregnant women should use the product with caution.
⚠ Do not step on the head of the treadmill.
⚠ Keep hands safe from moving parts.
⚠ Do not fold the treadmill if the power is on.
1.7 Care and Maintenance
1. Cleaning the Treadmill
- Turn off the treadmill and unplug the power cable.
- Apply an appropriate amount of soft detergent to a cotton cloth. To avoid damage, do not spray detergent directly onto the running belt, and do not use acidic or corrosive detergents.
- Do not wipe under the running belt.
2. Running Belt Adjustment
- Running belt inclines to the left: Turn the left adjustment screw 1/4 turn clockwise.
- Running belt inclines to the right: Turn the right adjustment screw 1/4 turn clockwise.
- Running belt slippage: Turn both the left and right adjustment screws 1/2 turn clockwise.
- After each adjustment, let the treadmill run for 1-2 minutes at a speed of 3-4 km/h and observe the correction. Readjust if necessary.
3. Running Belt Lubrication
- Turn off the treadmill and unplug the power cable.
- Lift the edge of the running belt and apply silicone oil to its inner surface. This is easier to manage when the treadmill is not fully extended.
- Before use, start the treadmill and let it run for 10-20 seconds at a speed of 3 km/h.
- Apply 5-10ml of silicone oil for lubrication each time to avoid any negative effects caused by excessive use of silicone oil.
- Lubricate the running belt every three months.
1.8 Replacement and Disposal
Battery Disposal
The battery contained in this appliance must be removed and disposed of. When replacing the battery, use only an original battery available from KingSmith's online parts store.
The battery compartment is located on the back of the appliance. Open the compartment by removing the screw in the cover with a suitable screwdriver, then press the bottom end of the locking clip on the connectors. Both sides of the connector can be separated by pulling them apart.
When inserting a new battery, push both connectors together and ensure the latch clicks into place.
Never dispose of empty batteries with household waste; instead, use appropriate public collection points. This also applies to batteries from defective devices.
Devices marked with the WEEE symbol (crossed-out wheeled bin) must be disposed of separately from household waste, as they contain valuable materials that can be recycled. Proper disposal protects the environment and human health. Local authorities or retailers can provide information on this.
