EasyTouch RV 356

Step 1: Power Off

Turn off the main power supply at the breaker box. This involves a 120/240 VAC breaker or a 12 VDC breaker or fuse.

[Diagram: Breaker box with power OFF indicated.]

Step 2: Remove Old Thermostat

Carefully remove the existing thermostat. This typically involves unscrewing it from the wall. [Diagram: Old thermostat labeled 'Coleman-Mach' being unscrewed.]

Step 3: Wiring

Observe the wiring connections. Note the wire colors (red, blue, orange, white, purple, grey) and their corresponding terminals on the old thermostat. [Diagram: Close-up of wires connected to old thermostat terminals.]

Step 4: Connect New Thermostat

Connect the wires from the wall to the corresponding terminals on the new EasyTouch thermostat. Ensure plugs are securely connected. [Diagram: Wire connectors plugging into the new thermostat. A green checkmark indicates 'Plug into EasyTouch'. A red X indicates an error. An arrow points to 'Otherwise See Manual'.]

Step 5: Install Sensor (if applicable)

If a separate temperature sensor is provided (often in a bag), follow instructions for its placement and connection. [Diagram: Temperature sensor in a bag, with reference to manual.]

Step 6: Mount New Thermostat

Mount the new EasyTouch thermostat unit to the wall using the provided mounting hardware. [Diagram: Mounting plate attached to wall, then new thermostat attached to plate.]

Step 7: Power On

Restore power by turning on the main breaker at the breaker box. This involves a 120/240 VAC breaker or a 12 VDC breaker or fuse. [Diagram: Breaker box with power ON indicated.]

Green Wire Configuration

If you have a green wire:

This configuration enables 'AUTO GEN-START'.

[Diagram: Settings icon ⚙️ → Wiring screen → Power Unavailable ? → Power Available ? for AUTO GEN-START.]

If you do not have a green wire:

Leave the default settings.

White Wire with Black Stripe Configuration

If you have a white wire with a black stripe:

This configuration enables specific 'SOURCES' for heating/cooling.

[Diagram: Settings icon ⚙️ → Wiring screen → Electrical hazard ⚡ → Heat sources ?/♨️ for SOURCES.]

If you do not have a white wire with a black stripe:

Leave the default settings.

Power Control

To turn the system ON:

[Diagram: Hand pointer selects Mode, then System ON ?.]

To turn the system OFF:

[Diagram: Hand pointer selects Mode, then System OFF ?.]

Fan Speed

To adjust fan speed:

[Diagram: Hand pointer selects Fan, then Full Auto ?.]

Select 'Full Auto' for optimal fan operation.

Cool Mode

To set cooling temperature:

[Diagram: Hand pointer selects Mode, then Cool ❄️, then 'Cool to 72 F' setpoint adjustment.]

Set the desired cooling temperature, e.g., 'Cool to 72 F'.

Heat Mode

To set heating temperature:

[Diagram: Hand pointer selects Mode, then Heat Pump ? or Furnace ♨️, then 'Heat to 68 F' setpoint adjustment.]

Select the heat source (Heat Pump or Furnace) and set the desired heating temperature, e.g., 'Heat to 68 F'.