Installation manual

Fitting Slide Runners

1. Obtain left hand side rack and left hand slide runner. Refer to the image for identification. (L = left hand side, R = right hand side)

   Diagram Description: An illustration showing a side rack with three horizontal wires. A slide runner is depicted being attached to the second wire from the top. An enlarged view shows how the rear clip of the slide runner attaches to the wire.

2. Fit slide rear clips to the rear of the wire at an angle as shown.

   Diagram Description: An enlarged view showing the rear clip of the slide runner being attached to the oven's side rack wire at an angle.

3. Push the slide's front clip over the wire until it secures with an audible click.

   Diagram Description: An enlarged view showing the front clip of the slide runner being pushed onto the oven's side rack wire until it clicks into place.

Slide runners may be fitted onto any of the side rack wire positions as highlighted in the diagrams.

Using Slide Runners

NOTE: For 60cm ovens, ONLY use the wire shelves provided in the accessory pack. These shelves are designed specifically for use with slide runners. Original wire shelves may continue to be used in positions without runners as normal or discarded.

To fit a shelf or tray to slide runners:

• With the slides fully pushed in, push the shelf or tray along the top of the slide until it hits the back post.
• Drop the front of the shelf or tray onto the slide ensuring it sits behind the front post of the slide.
• When fully inserted, the shelf/tray should not interfere with the closed oven door.

Diagram Description: Two diagrams illustrate the process of inserting a shelf into the oven using slide runners. The top diagram shows the shelf being pushed along the slide runner until it reaches the back post. The bottom diagram shows the shelf being dropped onto the front post of the slide runner. An inset in the bottom diagram shows the front post of the slide runner.

Side racks

• The side racks attach to each side of your oven.
• There is a left hand and a right hand version.
• Insert the rear peg into the rear access hole provided, ensuring that the peg is fully inserted.
• Then locate the front peg into the front access hole and push in firmly.

Diagram Description: The first diagram shows the side of an oven with a side rack being inserted. It highlights the left hand liner (shiny side touches the oven wall). The second diagram shows a close-up of the side rack attachment points, indicating the front peg and rear peg, and their corresponding holes on the oven's interior wall.