Q08 Selfie Stick Tripod - Instructions for Use

Unload and Load

Instructions for taking out and loading the selfie stick.

Taking out: [Illustration showing removal]

Loading: [Illustration showing insertion]

Replacement Battery

To replace the battery, pull out from the groove on the left to open the remote control cover.

[Illustration of battery replacement]

How to Use

1. Turn on: Long press the camera button for 3 seconds to turn on.
2. Bluetooth pairing: The indicator light flashes for 4 seconds to enter pairing state. The blue indicator light flashes during pairing. Use your mobile phone to search for "Gimbal Selfie" to match. The blue indicator light will go out after successful pairing.
3. Take a photo: When the selfie stick is connected to the mobile phone, short press the camera button and the blue light flashes.
4. No pairing: After booting, if there is no pairing connection for 5 minutes, it will automatically shut down.
5. Pairing: After turning on, if the selfie stick is connected to the phone and there is no operation for 10 minutes, it will enter dormant state, and it will automatically shut down after another 10 minutes of no operation.
6. Power off: In power-on and sleep mode, press and hold the camera button for 3 seconds to power off. The indicator light flashes and goes out.

Open the Tripod

Open outwards at the bottom of the handle to change into a tripod in seconds.

[Illustration showing tripod deployment]

How to Use PTZ (Pan-Tilt-Zoom)

Clamp the phone and maintain a natural balance.

Long press the PTZ power button for 5 seconds to turn on, and long press for 3 seconds to shut down.

After booting, the green light flashes to enter steady shooting mode. Shake the handle left and right, and the PTZ always keeps the same horizontal direction.

Click the power button of the gimbal stand. Manually dial left (right) more than 45° for 2 seconds, and the PTZ automatically rotates 90° to the left (right).

[Illustration of PTZ operation]

When the gimbal power is low, a flashing red light will remind you. Use the Micro USB port to charge. The red light will be on during charging and go out after charging is completed.

Micro USB interface

Selfie Stick Mode

When the gimbal is dead or turned off, slide the unlock button to change to tripod mode.

[Illustration of switching to selfie stick mode]

Remind

• The selfie stick is compatible with Android 4.2.2 and Android devices, and iOS 5.0 or above iPhones. (If you change the system's "volume key" function in the camera option, you must change it back to the default or "take photos" for the selfie stick to work normally).
• When clamping the phone, it must be pressed firmly against the phone clip.
• Stable Mode: Best used within 3 telescopic rods (within 50cm).
• Selfie Stick Tripod Mode: 5 telescopic rods are recommended (within 70cm).
• The battery must not be exposed to sunlight, fire, or similar overheating environments.

Thank you for your support!

[Logos: FC, CE, RoHS]