IKEA ORRSJÖN Wash-basin: Assembly and Installation Guide
Product by IKEA
Important Information
Note: Silicone sealant is not included with this product and must be purchased separately for installation. Ensure you have the necessary tools, such as a silicone sealant gun.
Product Overview
This document provides assembly instructions for the IKEA ORRSJÖN wash-basin. It details the components, required steps, and important considerations for a successful installation.
Parts Identification
The following parts are included or referenced in the assembly process:
Drain Assembly Components (RÄNNILEN system)
- Drain trap body
- Various pipe connectors and elbows
- Seals and gaskets
- Part numbers referenced: 10046279, 10097231, 10097281, 10097279, 10044928
Wash-basin Unit
The main wash-basin unit itself.
Assembly Instructions
Step 1: Prepare Cabinet and Apply Sealant
Apply silicone sealant to the designated edges of the cabinet where the wash-basin will be mounted. This creates a watertight seal between the basin and the cabinet. Use a silicone sealant gun for precise application.
Diagram Description: Shows a cabinet with sealant being applied to its top edges using sealant guns.
Step 2: Position the Wash-basin
Carefully place the ORRSJÖN wash-basin onto the prepared cabinet. Ensure it is correctly aligned with the cabinet edges as indicated in the detailed views.
Diagram Description: Shows the wash-basin being lowered onto the cabinet. Detail views highlight precise alignment with the cabinet front and sides.
Step 3: Seal the Wash-basin Edge
Apply a continuous bead of silicone sealant around the outer edge of the wash-basin where it meets the cabinet. This step is crucial for preventing water leaks. Allow the sealant to cure for approximately 3 hours (03:00:00) before proceeding or using the basin.
Diagram Description: Shows sealant being applied around the top edge of the wash-basin. A clock icon indicates a curing time of 3 hours.
Step 4: Assemble the RÄNNILEN Drain System
Assemble the components of the RÄNNILEN drain system according to the provided diagrams. This involves connecting the various pipe sections, elbows, and seals to form the complete trap.
Diagram Description: Shows the individual parts of the RÄNNILEN drain system being connected together, forming the trap and outlet pipes.
Step 5: Connect Drain to Sink
Connect the assembled drain system to the outlet of the ORRSJÖN wash-basin. Ensure all connections are secure and properly seated. A soap dispenser icon is shown, likely representing the drain outlet or a related component.
Diagram Description: Shows the drain assembly being connected to the sink's drain opening. An icon resembling a soap dispenser is visible, possibly indicating the drain outlet.
Step 6: Install Seals
Insert and secure any necessary seals or gaskets within the drain assembly to ensure watertight connections.
Diagram Description: Shows a seal being placed into a part of the drain assembly.
Step 7: Adjust Drain Assembly
Adjust the position and angle of the drain assembly as needed to ensure it fits correctly and allows for proper drainage. Arrows indicate adjustment possibilities.
Diagram Description: Shows the drain assembly being adjusted, with arrows indicating movement and rotation. Icons indicate correct and incorrect configurations.
Step 8: Final Drain Installation
Complete the installation of the drain components into the wash-basin. Detailed views show the final assembly of the drain parts within the sink's drain hole.
Diagram Description: Close-up views show the final assembly of the drain components into the underside of the wash-basin. Part numbers are visible.
