Instruction Manual for Goldair models including: GCT373, 2000W Ceramic Tower Heater, Ceramic Tower Heater, GCT373, Tower Heater

PowerPoint Presentation

Leon White

Check out the User Manual for safety, operational and installation instructions.

2000W Electronic Ceramic Tower Heater – Goldair.nz

Not Your Device? Search For Manuals / Datasheets:

File Info : application/pdf, 8 Pages, 347.01KB

Document
GCT373 IM 2021 ?v=1643318424
Operating Instructions
2000W CERAMIC TOWER HEATER
Model: GCT373

General Care and Safety Guide
YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE
INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.  This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they are supervised or have been given instruction concerning the use of the appliance by a person responsible for their safety.  Children should be supervised to ensure that they do not play with the appliance.  If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
WARNING: You must not cover this appliance. Covering this appliance
presents fire risk and will activate the safety fuse; permanently disabling the unit.
WARNING: Do not use this appliance in small rooms when they are
occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
WARNING: To reduce the risk of fire, keep textiles, curtains, or any
flammable material a minimum distance of 1 metre from the air outlet.  Use only the voltage specified on the rating label of the appliance.  The heater must not be located immediately below a wall socket.  Keep all objects at least 1 metre from the front, sides and rear of the
appliance.  This appliance is intended for household use only and not for commercial or
industrial use.  Indoor use only.  Use this appliance only as described in this manual. Any other use is not
recommended by the manufacturer and may cause fire, electric shock or injury.  Do not use the appliance if it has been dropped or damaged.  The common cause of overheating is deposits of dust or fluff in the appliance. Ensure these deposits are removed regularly by unplugging the appliance and vacuum cleaning the air vents and grills.

General Care and Safety Guide
 Never use the appliance to dry clothes.  Always unplug appliance when not in use.  When the appliance has been unpacked, check it for transport damage and
ensure all parts have been delivered. If parts are missing or the appliance has
been damaged, contact the Customer Services Team.  Do not use if there are visible signs of damage to the appliance.  Do not connect the appliance to mains supply until completely assembled and
adjusted.  Ensure hands are dry before handling the plug or main unit.  Ensure appliance is on a flat, stable, heat-resistant surface.  Do not operate with cord set coiled up as a heat build up is likely, which could
be sufficient to become a hazard.  Carry out regular checks of the supply cord to ensure no damage is evident  Do not operate this appliance with a damaged cord, plug or after the appliance
malfunctions or has been dropped or damaged in any manner. Take to a
qualified electrical person for examination, electrical service or repair.  Do not twist, kink or wrap the cord around the appliance, as this may cause the
insulation to weaken and split. Always ensure that all cord has been removed
from any cord storage area and is unrolled before use.  It is recommended that this appliance is plugged directly into the wall socket.
Power boards are not rated to supply power to high wattage appliances.  A correctly specified, undamaged extension cord may be used with this
appliance provided it is used in a safe manner.  Do not remove plug from power socket until the appliance has been switched
off.  Do not remove plug from power socket by pulling cord; always grip plug.  Do not place cord under carpet or cover with rugs or furniture. Arrange the cord
so it cannot be tripped over.  Don't place appliance on bedding or on thick & long carpet where the openings
may get blocked.  Switch off and use handle provided when moving  Do not place appliance close to radiant heat source.  Do not insert or allow foreign objects to enter any ventilation or exhaust
opening, as this may cause an electric shock, fire or damage to the appliance.  Do not sit on the appliance.  Do not use abrasive cleaning products on this appliance. Clean with a damp
cloth (not wet) rinsed in hot soapy water only. Always remove plug from the
mains supply before cleaning.  Do not operate in areas where petrol, paint or other flammable liquids are used
or stored.  Do not use this appliance in the immediate surrounds of a bath, a shower, or a
swimming pool or other liquids.

General Care and Safety Guide
 The appliance must not be immersed in any liquids.  There are no user serviceable parts installed in the unit.  Do not place the unit in wardrobes or other enclosed spaces as this may cause
fire hazards.  This unit is not supposed to be used in or around locations where foodstuffs,
works of art or delicate articles of science, etc. are stored.  If your appliance does not work, or is not working properly, contact the place of
purchase or the Customer Services Team.
Operating Your Heater
Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all packaging has been removed from the unit before use. Please follow the below instructions.
WARNING: In order to avoid overheating or fire, do not cover the heater. WARNING: Keep all objects at least 1 metre from the front, sides and rear
of the appliance.
WARNING: Do not use this heater with a programmer, separate timer,
remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
WARNING: Never leave this heater unattended when in use.
Ensure heater is on a flat, stable, heat-resistant surface. Once the heater is in a safe operating position and all switches are in the off position, insert the power plug into the mains outlet and switch on.
CAUTION: Ensure the power cord is not tight because if pulled it may
partially pull the plug from the socket. A partially inserted plug will overheat the plug and socket and could result in fire.

Operating Your Heater
Control Panel

ON/OFF BUTTON This button will turn the heater control panel on. To turn the unit off, press the On/Off button on the control panel again.

MODE BUTTON Select between LOW heat or HIGH heat.

THERMOSTAT Touch the up or down arrow buttons to adjust the temperature as your desired comfort setting from 15 to 30 degrees Celsius. After the temperature is set, the display will show room temperature.

When the room temperature reaches the preset temperature, the heating function will cut off automatically. When the room temperature is lower than preset temperature, the low or high heating will turn on automatically.

TIMER This heater is equipped with a 12 hour countdown timer. This enables you to preset the appliance to switch off automatically from 1 to 12 hours in 1h increments. Touch the button to set the timer.

OSCILLATION BUTTON This button turns the heater oscillation function on and off.

CHILD LOCK To enable/disable Child Lock function, hold the

buttons down for 2-3 seconds.

Operating Your Heater
SAFETY DEVICES This appliance has two protection devices:  Tilt Switch - this will automatically turn the appliance off if the appliance is not in
the correct operating position.  Resettable Thermal Link - this will automatically disconnect the power to the
appliance at a pre-set overheat temperature. After cooling down it will reset and power on again. If this occurs, investigate what is causing the appliance to overheat.
CAUTION: The appliance generates heat during use. Precautions must be
taken to prevent the risk of burns, scalds, fires or other damage to persons.
CARE AND CLEANING The heater requires regular cleaning to ensure trouble free operation:  Unplug the heater from the mains supply before cleaning.  Ensure that the heater has been allowed to cool down completely before cleaning.  The common cause of overheating is deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly by unplugging the appliance and vacuum cleaning the air vents and grills.  Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.  Never use solutions such as petrol, thinners or polishing agents.  Ensure the heater is dry before plugging back into the mains supply.  Do not attempt to dismantle the heater.  There are no user serviceable parts. For service or repair, contact an authorised electrical service technician.

PROOF OF PURCHASE To receive warranty retain receipt as proof of purchase.

SUPPORT AND TECHNICAL ADVICE

Goldair  New Zealand Monday  Friday 8am-5pm Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]

Goldair  Australia Monday  Friday 8am-5pm Phone +61 (0)3 9365 5100
Phone 1300 465 324
[email protected]

Two Year Warranty
Thank you for purchasing this Goldair product. Your product is warranted against faults and manufacture when used in normal domestic use for a period of two years. In non-domestic use Goldair limits the voluntary warranty to three months.
Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault during the warranty period.
This warranty excludes damage caused by misuse, neglect, shipping accident, incorrect installation, or work carried out by anyone other than a qualified electrical service technician.
PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.
The benefits given to you by this warranty are in addition to other rights and remedies available to you under law in relation to the goods or services to which this warranty relates.
In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act (1993).

Goldair  New Zealand CDB Goldair PO Box 100-707 N.S.M.C Auckland
Phone +64 (0)9 917 4000 Phone 0800 232 633 www.goldair.co.nz
Goldair Two Year Warranty (IMPORTANT: Please complete and retain this warranty card)
Name

Goldair  Australia CDB Goldair Australia Pty
PO Box 574 South Morang Victoria, 3752
Phone +61 (0)3 9365 5100 Phone 1300 GOLDAIR (1300 465 324)
www.goldair.com.au

Address

Place Of Purchase Name Of Product Attach a copy of the purchase receipt to this warranty card

Date Of Purchase Model Number

Due to continual design improvements, the product illustrated in this User Manual may differ slightly from the actual product.

New Zealand PO Box 100707, North Shore Mail Centre, Auckland, 0745 www.goldair.co.nz
Australia PO Box 574, South Morang, Victoria, 3752 www.goldair.com.au



References

Microsoft PowerPoint for Microsoft 365