HeadRush HRF 5020 Noise-Cancelling Wireless Over-Ear Headphones
Model: HRF 5020
About Bluetooth ®
The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth ® SIG, Inc. and any use of such marks by The Source (Bell) Electronics Inc. is under license. Other trademarks and trade names are those of their respective owners.
What's Included:
- HRF 5020 Headphones
- Micro USB charging cable
- 3.5 mm audio cable
- Instruction Manual
Identifying the Parts of Your Headphones
A diagram shows the different parts of the headphones:
- 1. Adjustable headband
- 2. Volume Down – / Previous song ⏹
- 3. Volume Up + / Next song ⏹
- 4. MFB button (multifunction button) ⏹
- 5. Micro USB charging port
- 6. 3.5 mm audio jack
- 7. Rotatable bracket
- 8. Noise cancelling button (NC)
- 9. Microphone
Introduction
Thank you for purchasing the HeadRush HRF 5020 headphones. Please read the following instructions to maximize your listening experience.
Charging
Charge your headphones fully before first use using the included micro USB cable. Recharge when the battery is low. The red LED indicates charging and turns off when fully charged. A flashing red LED every 5 seconds accompanied by beeping every 30 seconds signifies low battery power. Full charging takes approximately 2 hours.
Battery Capacity Status
When connected to a smartphone, the headphone battery status is displayed in the upper right-hand corner of the device screen.
Turning On and Pairing
Pairing with one device:
- Press and hold the MFB button for 5 seconds to turn on the headphones and enter pairing mode. The headphones will flash red and blue.
- Enable Bluetooth on your device and select "HRF 5020" to connect.
Note: The headphones will automatically connect to the last connected device when turned on, provided Bluetooth is enabled and the device is within range.
Pairing with Two Devices
The headphones support multi-connection, allowing pairing with two devices simultaneously. You can receive calls from either device.
- After pairing with the first device, turn the headphones OFF.
- Repeat the pairing procedure with the second device.
- On the first device, select "HRF 5020" from the list of found devices to connect.
Operation
| Action | Instruction |
|---|---|
| Power ON/OFF | Press and hold the MFB for 5 seconds. |
| Adjust volume | Press and hold the V+/V- button for 3 seconds. |
| Play/Pause | Press the MFB once to pause. Press again to play. |
| Next track | Press the ⏹ button once. |
| Previous track | Press the ⏹ button once. |
| Answer or end a call | Press the MFB once to answer or end the call. |
| Reject a call | Press and hold the MFB for 3 seconds. |
| Redial | In standby mode, double-press the MFB. |
3.5mm Line-In
Insert the supplied audio cable into the headphone jack. Note: When using the 3.5 mm line-in, the Bluetooth connection will be disabled.
Active Noise-Cancellation (ANC) Function
Switch ANC to "ON" to reduce surrounding noise. The LED will turn green when ANC is active.
Clear Paired Memory
Turn on the headphones. Press and hold the V+ and V- buttons simultaneously for approximately 6 seconds until the headphones beep. Then, turn off the headphones to complete the reset.
Using Your Headphones
- Adjust the headband for a snug and secure fit for optimal sound and comfort.
- Place the headphones on the correct ears, indicated by "R" for the right ear and "L" for the left ear.
- For physical activities, ensure the cord is positioned in front of your head and body to keep the headphones in place.
Protecting Your Headphones
- Clean headphones with a soft cloth. Do not use liquids.
- Keep headphones clean and free of debris.
- To disconnect the plug from your device, pull from the plug itself, not the cable.
- Avoid wrapping headphones around a device while it is still plugged in, as this can put unnecessary pressure on the plug/cord connection.
Warnings
- Do not insert plugs into electrical sockets.
- Listening to headphones at high volume for extended periods may cause hearing damage.
- Consult a physician before use if you have a pacemaker or other electrical medical devices.
- Clicks may occur when switching Hi-Fi system sources or plugging in headphones. Set the volume to minimum before these actions to prevent hearing damage.
- Do not use headphones while driving or cycling.
- Supervise children when using this equipment. This product is not a toy. Small parts may pose a choking hazard. Keep away from children under 3 years of age.
Specifications
| Specification | Details |
|---|---|
| Bluetooth ® version | 5.0 |
| Bluetooth ® profiles | HSP/HFP/A2DP/AVRCP* |
| Talk time | 14 hours |
| Stand-by time | 5 days |
| Music play time | 14 hours |
| Wireless range | 10 m (32 ft.) |
| Driver diameter | 40 mm |
| Impedance | 32 Ω |
| Sound pressure level | 95 dB ± 3 dB |
| Frequency response | 20 Hz - 20 kHz |
| Battery | 250 mAh Polymer lithium |
| Recharging input | DC 5V, 500mAh |
*HFP = Handsfree profile, HSP= Handset profile, A2DP=Advanced audio distribution profile, AVRCP=Audio/video remote control profile.
**Approximate playback time; battery life depends on individual use and may vary.
Industry Canada Notice RSS247
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of Industry Canada.
IC: 255A-8088038
The Source Warranty
The Source warrants this product against defects in materials and workmanship for 12 months from the purchase date. During this period, return the product and proof of purchase to any The Source store or participating dealer for replacement (if available) at no charge. Misuse or accidental damage voids this warranty.
This warranty applies only to products purchased through The Source company-owned stores or participating dealers in Canada. While this warranty grants specific legal rights, you may have additional statutory rights that vary by country, state, province, or other governmental entities where The Source operates. This warranty is subject to all statutory rights applicable in Canada.
