Instruction Manual for EMANER models including: 7042 Dimmable Flood Light, 7042, Dimmable Flood Light, Flood Light, Light
EMANER Dimmable Flood Light, Switch-Controlled, 110-120V Corded Exterior LED Security Light 24Watt (250W Equivalent) Wall Dimmer Change Brightness, Daylight White for Porch, Garage, Yard, 1-Pack
EMANER Dimmable Flood Light, Switch-Controlled, 110-120V Corded Exterior LED Security Light 24Watt (250W Equivalent) Wall Dimmer Change Brightness, Daylight White for Porch, Garage, Yard, 1-Pack - Amazon.com
INSTALLATION INSTRUCTIONS Model 7042 WARNING:TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO TURN POWER OFF AT CIRCUIT BREAKER OR FUSE . NOTES: Some codes require installation by a qualified electrician. To avoid hazard, read instruction carefully before installing and save this instruction. Customer support: support@emaner.com 1. Hardware Package (included): #5/32 X 3/4 in X3 Mounting Screw 1# #5/32 X 1/2 in X2 Mounting Bracket Screw #5/32 X 3/4 in X1 Fixture Mounting Screw Decorativecover Mounting Strap X1 Wire ConnectorX3 Mounting Screw 2# Expansion Screw Gasket x1 2. Important to Know: The light control requires 100-130-volts AC. Some codes require installation by a qualified electrician. This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations. Maximum Wattage: 28W Working Temperature Range: -22ºF ~ 113ºF 3. Features: Energy saving LED security light fixture. When the sensor triggered the passing of person, car or animal, the light will turn on, and then turn off after 1 minute. Sensing distance: 4-8meters. IP65 waterproof rating of this product. 4. Installation Notes: Motion sensor toward outside Page 1/2 5. Installation Step: Take apart the back plate from the lamp body. 1). Turn off power to the work area at the circuit breaker main or fuse box. Note: do not rely on the wall switch turns off the power. 2). The Yellow&Green- Earth Wire (Ground Wire) is fixed to the aluminum mounting strap. Fix the aluminum mounting strap to the outlet box. 3). Fix the gasket to the outlet box. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows: Black - Live Wire (Hot Wire) White - Neutral Wire (Naughty Wire) Green to Ground wire Carefully tuck the wires back into the outlet box. Fix the Back Plate to the mounting strap. 4). Fix the lamp body to the Back Plate, use the fixture mounting screw(longest), put on the white decorative cover after fix the lamp body. Turn on power to test the light in TEST mode. CAUTION: Be sure to caulk completely where the back plate meets the wall surface to prevent water from seeping into the outlet box. 6. Product description: Model No. Maximum Wattage Luminous Flux Surface Color Lens finish CCT CRI (Ra) Input Voltage Power Consumption Lifespan Motion Sensor Time Delay 7042-28W-XX(XX=WH / BK) 28W 1400lm*2-Head White/ Black Frosted (Anti-glare) 3000K / 4000K / 5000K 80 100~130V AC, 60Hz 14W*2-Head 50000Hours 1minute Page 2/2WPS 文字