BILT HARD 20 INCH OSCILLATION PEDESTAL FAN

SAFETY INFORMATION

ASSEMBLY INSTRUCTION

Simple assembly is required to use this fan.

1. Insert the end of the outer pole into the base hole, align the screw holes on the base and the outer pole, then insert the screws through the holes, and tighten them up with nuts under the base. See Fig. 1 and 2.
2. Loosen the extension pole nut onto the outer pole. See Fig. 3.
3. Insert the cap through the outer pole. See Fig. 4.
4. Thread extension pole nut onto threads of inner pole.
5. Take fan motor housing and insert it into inner pole, tighten the neck set screw securely. See Fig. 5.
6. Remove four mounting screws from motor housing where indicated to use for rear guard then assemble rear guard onto motor housing using screws, tighten the 4 screws securely. See Fig. 6 and 7.
7. Place fan blade onto motor shaft. Tighten blade by set screw securely on flat surface on motor shaft. See Fig. 8.
8. Attach front guard to rear guard with hook clip centered on the top above wire handle. Press remaining guard clips onto rear guard to securely attached front guard. Do not operate fan without guard in the place. See Fig.9 and 10.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Fig. 9

Fig. 10

Parts List:

• 1. Front grille
• 2. Blade
• 3. Blade screw
• 4. Rear grille
• 5. Motor shaft
• 6. Motor
• 7. Oscillating switch
• 8. Speed switch
• 9. Power cord
• 10. Neck
• 11. Extension pole
• 12. Screw nut
• 13. Outer pole
• 14. Decorative cap
• 15. Base

OPERATION INSTRUCTION

SPEED CONTROL:

Select air speed by setting switch at the back of the fan: Low, Medium and High speed for desired air movement.

It is normal for the motor to feel warm to the touch after continuous operation. This fan features a thermostat that will automatically shut off if it overheats to 135°C for any reason. If it happens, unplug the fan from the outlet immediately.

OSCILLATION CONTROL:

Control the fan oscillation by pressing the rocker switch on the fan motor housing.

SERVICING INSTRUCTION

1. Unplug the fan by gripping the plug directly.
2. Open fuse cover.
3. Select a suitable tool, small flat screwdriver or similar tool, and insert the tip of the tool into the gap of the plug face.
4. Press the tool down, then pry the protection door of the fuse out until the fuse is fully accessible.
5. Carefully remove the fuse.
6. To avoid risk of fire, make sure replacement fuse is a 5 Amp 125V Fuse.
7. Place the new fuse in the slot and carefully press down by pushing gently on the copper caps on either side. Be careful not to push too hard to avoid damage to the fuse.
8. Close fuse cover. Push the protection door back into place. If the door will not go back into original place, ensure that the fuse is properly situated. Be careful not to force the door as this could damage the fuse or the door.

[Slide Cover to Open]

CARE AND MAINTENANCE

1. Unplug the appliance before cleaning.
2. Do NOT use water directly on the fan for cleaning metal surfaces. Never immerse the fan or any wires in water.
3. Slightly moisten a cloth and then wipe off the surface of the fan. In order to remove the dust from the grill, use a vacuum cleaner or remove the front grill by removing the securing screw on the edge of the grill with a screwdriver.
4. After cleaning, remount the grill and fasten the securing screw on the edge of the grill.