VOLA S10 & S10US Angle Stop Valve Installation Guide

This guide provides step-by-step instructions for installing the VOLA S10 and S10US angle stop valves.

Product Overview & Dimensions

The VOLA S10 and S10US are angle stop valves designed for plumbing installations. Key dimensions include:

Main body diameter: Ø60 mm (2 3/8")
Overall length: 107 mm (4 1/4")
Inlet connection size: 3/8"
Outlet connection size: 14 mm (1/2")
Outlet diameter: Ø10 mm

Installation Steps

Step 1: Set Valve to OFF

Turn the valve handle to the OFF position. [OFF]

Step 2: Prepare Wall Connection

Prepare the wall connection point. Apply sealing tape to the threaded pipe where the valve will connect. [Sealing tape]

Step 3: Assemble Valve Components

Assemble the valve body components. Ensure all washers and seals are correctly positioned for a watertight seal.

Step 4: Connect Water Supply Lines

Connect the water supply hoses (e.g., VOLA standard hose) to the valve inlets. The connection size is 09/16". [Supply connection arrows]

Step 5: Connect Water Outlet

Connect the water outlet pipe to the valve. [Outlet connection]

Step 6: Turn Valve ON and Check Flow

Turn the valve handle to the ON position. Water should flow through the valve. [ON] [Water flow]

Step 7: Inspect for Leaks

Carefully inspect all connections for any signs of leakage. Allow water to run for approximately 30 seconds to ensure proper function and check for drips. [Inspect for leaks] [Water drops] [Timer]

Step 8: Final Installation

The VOLA S10 or S10US angle stop valve is now installed and ready for use.

Parts Identification (Exploded View)

The following components are part of the VOLA S10/S10US valve assembly, as shown in the exploded view diagram:

566 (Ø60) - Main body component
614 - O-ring
S10US specific parts: 587 (Ø3/8")
562 - Component
563 (Ø10) - Component
559 - Component
565 - Component
20 - Component
22 - Allen key

For detailed part identification and assembly, refer to the manufacturer's diagrams.