JCHR35W1A/2A 6-channel LED Remote Controller User Manual
01 Product Info
JCHR35W1A Hand-held 6-channel LED remote controller
Description: A rectangular, hand-held remote control unit. It features a central square button, directional buttons (Up, Down, Left, Right), a 'Fav' button, and a power button. The back of the unit contains a battery compartment for a CR2450 3V battery and a 'Prg' button.
JCHR35W2A Wall-mounted 6-channel LED remote controller
Description: A square-shaped unit designed for wall mounting. It includes a central circular pad with directional indicators (Up, Down, Left, Right), a central square button, and a 'Fav' button. An LED indicator strip is located at the top. The back of the unit contains a battery compartment for a CR2430 3V battery and a 'Prg' button.
02 Buttons
a. Front (JCHR35W1A Hand-held)
The front of the hand-held remote features the following controls:
- LED Indicator
- Up [Up Arrow]
- CH- [Channel Down Button]
- Down [Down Arrow]
- Fav [Favorite Button]
- CH+ [Channel Up Button]
- Stop [Stop Button]
a. Front (JCHR35W2A Wall-mounted)
The front of the wall-mounted remote features the following controls:
- LED Indicator
- Up [Up Arrow]
- CH- [Channel Down Button]
- Down [Down Arrow]
- Fav [Favorite Button]
- CH+ [Channel Up Button]
- Stop [Stop Button]
03 Models & Parameters
(more info please refer to the nameplate)
| Electrical Specification | Standard |
|---|---|
| Battery Type | Hand-held: CR2450*3V*1 Wall-mounted: CR2430*3V*2 |
| Working Temperature | -10℃-50℃ |
| Radio Frequency | 433.92MHz±100KHz |
| Transmit Distance | >=30m indoor |
04 Caution!
- The transmitter should not be exposed to moisture or impact, so as not to affect its life.
- During use, when the remote control distance is significantly shorter or less sensitive, please check whether the battery needs to be replaced.
- When the battery voltage is too low, the orange LED will flicker during operation.
- Please properly dispose of used batteries according to the local garbage classification and recycling policy.
05 Instructions
a. Prohibit Dual-key Operation
Step 1: Prohibit Dual-key Operation
Press and hold the [Program Button] (labeled 'P') for 10 seconds (Prgx10s). The [LED Indicator] will flicker, indicating that dual-key operation is prohibited.
Step 2: Activate Dual-key Operation
Repeat the above step (pressing and holding the [Program Button] for 10 seconds) to activate dual-key operation.
Note: When dual-key operation is prohibited, these programming setting functions are not allowed.
b. Number of Channels Setting
To set the channel numbers:
Press and hold the [Favorite Button] and [Channel Up Button] simultaneously for 3 seconds (Fav&CH+ x3s). The [LED Indicator] will flicker.
Perform a "Short press" to increase or decrease channel numbers.
Perform another "Short press" to confirm the channel selection.
Note: When all LEDs are lit, that is channel 0 (All channels move together).
c. For other operations
For other operations, please refer to the motor operation instruction.