VOVO USA Installation Manual

1 Cautions before Installation

Installation Space: Secure adequate installation space in the bathroom. Check that the toilet does not obstruct the bathroom door. Ensure the water outlet is at least 100mm (3.93 in) away from the floor. Improper installation may cause wall discoloration.

Water Pressure: A minimum water pressure of 1.5 kgf/cm² (0.15 MPa) is required. Insufficient pressure may lead to improper flushing. The maximum allowable water pressure is 7.5 kgf/cm² (0.75 MPa).

Drain Position: Verify that the water supply pipe and drain pipe are correctly positioned before installation.

2 Drawing for Installation

Dimensions are provided in millimeters (mm) and inches (in).

Model Series:

• PB-707S, PB-101S
• TCB 090SA, TCB 090S, RTB 090WA, RTB 090W, TC-090, TC-090W
• TCB 9100WA, TCB 9100GA, TCB 9100W, TCB 9100G
• TCB 8100, TCB 8200

[Diagram showing various toilet models with dimensions and installation clearances]

3 Accessories

Accessories are divided into Type A and Type B based on product specifications.

A type Installation Accessories

Included: Remote control, Wall Mount, Wax Ring, Conversion Nut, AA Batteries (x3), Screws (x2), Anchors (x2), Water Hose (Thin)

[Diagram showing A type accessories]

B type Installation Accessories

Included: Remote control, Wall Mount, Wax Ring, Rubber Washer, Water Shutoff Valve, AA Batteries (x3), Screws (x2), Anchors (x2), Water Hose (Thick), Strainer Filter

[Diagram showing B type accessories]

4 Installation

A type Installation Accessories

• Attach the provided water hose to your water shutoff valve.
• [Diagram showing hose connection to shutoff valve]
• Note: A conversion nut may be needed for 1/2" water shutoff valves. Screw the conversion nut into the 1/2" side of the hose before connecting.

B type Installation Accessories

1. Close the water gauge.
2. Remove dust and sand from the water inlet when installing the shutoff valve.
3. Wind Teflon tape around the water pipe.
4. Connect the pipe with the shutoff valve.
5. Connect the Strainer Filter.

[Diagram showing B type installation steps]

Connect Hose

1. Fix the hose to the flushing adapter first.
2. Turn the hose nut clockwise to connect the hose.

[Diagram showing hose connection steps]

How to install the Ceramic

• Press firmly. Apply weight evenly. Do not move after placement, as the water-tight seal may break. A team of two people is recommended for correct placement of the toilet base.
• [Diagram showing ceramic installation with emphasis on firm placement and even weight distribution]

5 Connect Bidet to Toilet

1. Assemble the toilet with bidet, jet spray outlet, and bowl washing outlet.
2. Insert the hose into the filter.
3. Insert the bidet's fixing hook onto the toilet's fixing hook until it "clicks".

[Diagram showing bidet attachment to toilet, highlighting connection points and fixing hooks]

A type: [Diagram showing A type connections]

B type: [Diagram showing B type connections]

6 Connect Power

1. Insert the power plug into the outlet.
2. Press the Flush button. Water will fill the ceramic bowl.

[Diagram showing power plug insertion and flush button]

Note on Water Pressure: If water overflows the rim during bowl cleaning in areas with high water pressure, use a screwdriver to turn the shutoff valve clockwise to reduce the water pressure.

[Diagram illustrating turning the shutoff valve clockwise]