John Lewis Calia Dining Table 190x95

Welcome & About This Product

Thank you for purchasing the Calia Dining Table. Please read the instructions and warnings carefully before use, to ensure safe and satisfactory operation of this product.

At John Lewis, we are committed to making great products possible. From our in-house Design Team, to our Buyers, we work together to bring great design to life. Our expert Product Technologists work collaboratively with our buyers and suppliers to assure the legality, safety and quality of the product we sell. We are all committed to designing and developing products to the highest industry standards.

We hope you are happy with your product and welcome any feedback or comments you may have.

The John Lewis Team

Time to assemble: 30 Minutes

People to assemble: 2

Important Safety Information

Warnings

• The product should only be used on firm, level ground.
• Keep small parts out of reach of children.

Do's

• Ensure the product is fully assembled as illustrated before use.
• Check the pack and make sure you have all the parts listed.
• Check all screws or bolts are tightened and inspect regularly.
• Make sure the legs remain in contact with the ground at all times.

Don'ts

• Do not over tighten screws or bolts.
• Do not stand on the product.
• Do not use power tools to construct as overtightening and panel failure may occur.

Illustrations show correct procedures: checking parts against a list, ensuring screws are tight, and legs are stable. Incorrect practices include overtightening, standing on the product, and using power tools.

Product Assembly

Parts List

Diagram shows the table top (1) and two table legs (2) with arrows indicating how they connect.

Fixtures and Fittings

Fixtures and fittings supplied (actual size):

A scale diagram shows measurements in millimeters from 0 to 70.

Fixtures and fittings supplied (not actual size):

Diagrams show individual components: bolts, washers, felt pads, and a wrench.

Assembly Steps

Step 1

Attach the table legs (Ref 2) to the underside of the table top (Ref 1). Arrows indicate the legs should be lowered into position.

Diagram shows two U-shaped legs being attached to the table top.

Step 2

Secure each leg using bolts (A), spring washers (B), and flat washers (C). Use the provided wrench (E) to tighten. Felt pads (D) are applied to the bottom of the legs.

Close-up diagram shows the order of fitting: bolt, spring washer, flat washer, securing the leg to the table top. The main diagram shows both legs fully attached.

Care Guide

Care and Maintenance

Wood Furniture

Wood displays different grain patterns depending on how it is cut. For example, the 'medullary ray' in oak furniture is a mark of good quality timber and a characteristic of its natural beauty. Some furniture is deliberately aged or rustic. Wood veneers also create distinctive patterns. All timber and veneer surfaces change colour and mellow over time. New furniture may vary in shade from previously purchased items.

How to Care for Your Wood Furniture

Your Calia furniture should be dusted or wiped over with a damp cloth. Do not use abrasive cleaners. Spray polishes are best avoided as they contain silicones that can spoil the furniture's surface over time. Protect all surfaces from heat and liquids using mats and coasters. Wipe up spills immediately. Ensure a mat or pad is placed under if you are writing.

While our furniture endures most home temperatures, avoid placing it next to heat sources like radiators or fires. Be particularly careful with solid wood, as low humidity caused by home heating can lead to warping.

How Often Should the Furniture Be Treated with Oil?

1. Preferably before use.
2. When necessary, and we suggest as often as every three months.

How to Apply Oil to the Piece of Furniture

1. Apply plenty of oil with a clean cloth. Table tops must be treated underneath as well as on the top side. (Do not drop oil on the floor!)
2. After 15 minutes, polish with a sandpaper sponge or fine sandpaper (no. 150) along the grain of the wood.
3. Polish off remaining oil with a clean, dry cloth.
4. Do not use the item until the oil is completely absorbed.

Your furniture is already oil-treated from the factory. We recommend using Woca “Worktop oil – natural” – item no. 527713AA (0.75 L), available at www.wocadenmark.co.uk.

Safety Instructions

• Never drag furniture when moving it; always lift it.
• Periodically check all fixings to ensure none have come loose and retighten when necessary.
• Take care when handling or moving the furniture, as careless handling may cause damage or injury.
• Furniture can be dangerous if incorrectly installed. Assembly should be carried out by a competent person. No liability will be accepted for damage or injury caused by incorrectly installed or assembled furniture.

Retain these instructions for future reference.