Knog Blinder 600 Quick Start Guide

What's in the Pack

• Knog Blinder 600 Light
• Bar Mount

Operation

Note: The Blinder 600 is packaged in DEMO-MODE. To enable full function, connect it to a USB-C charger.

Power Button Functions:

• Long Press (2 seconds): ON/OFF
• Quick Press: Change Mode
• Double Press: Toggle between Steady & Flash Modes
• Quick Press (when OFF): Check Battery Status

Charging

Important Temperature Note: For optimal battery life, charge within 15°C - 30°C (59°F - 86°F). Charging will be suspended below 0°C (32°F) or above 45°C (113°F) to protect the battery. ⚠️

1. Lift the charging-port hatch. ⬆️

2. Insert a USB Type-C charging cable.

The power button will glow amber ? while charging.

Once fully charged, the power button will glow green ?. The green light will turn off after 1 minute.

Battery Status

When the light is switched OFF, a quick press of the power button indicates the battery status:

Visual Indicator:

100% (Green ?), 75% (Green/Yellow ?), 50% (Yellow ?), 25% (Orange ?), 10% (Red ?)

Warning: If the power button light is flashing red ?, the light's output will be reduced to 30% to preserve runtime. ⚠️

Mounting

Bar Mount

The Blinder 600 is compatible with various bar diameters:

• 22.2 mm Ø BAR
• 26 mm Ø BAR
• 31.8 mm Ø BAR
• 35 mm Ø BAR

Select the corresponding hole on the mount to suit your bar diameter.

Attachment Steps:

1. Firmly hold the mount in place and stretch the strap downwards. ⬇️
2. Pull the strap around the bar and secure it onto the hook.
3. Place the light into the cradle.
4. Complete mounting by pulling up on the tab while applying downward pressure to click the light into position.

Ensure the light is secure before riding!

To Remove: Press down on the tab and gently pull the light away from the cradle.

Under Mount (Sold Separately)

The under-mount allows for alternative mounting positions.

States: LOCKED / UN-LOCKED. The UN-LOCKED state is indicated by a lever that can be rotated to secure the mount.

Attachment Steps:

1. Place the light inside the mount in the UN-LOCKED position.
2. Lock the under-mount.

Ensure the under-mount is locked before riding. Do not ride with the under-mount unlocked! ⚠️

Refer to your Go-Pro or computer mount instructions to complete the Blinder under-mount installation.

Modes & Runtimes

Warranty & Support

Designed by Knog, Melbourne, Australia.

2 Year Warranty

Visit: KNOG.COM