LUTRON PD-6WCL Caseta Wireless In-Wall Dimmer with Pico Remote Control
Identify existing wiring
Two switches control the lights (3-way installation)
Important note:
- If one switch controls the lights (single-pole installation) See quick-start guide that came with your in-wall dimmer
- If three or more switches control the lights(multi-location installation) See page 36 for details
What you need for a 3-way installation
Choose a location for your Caséta Wireless in-wall dimmer
Choose which location you want the Caséta Wireless in-wall dimmer installed in. This will be Location 1.
Turn power off at circuit breaker
WARNING: Shock Hazard. May result in serious injury or death. Turn off power at circuit breaker before installing the unit.
Remove existing switch from wall
Location 1
Tag and disconnect wires from the existing switch
Location 1: Place tag – to identify wire on different color screw
Remove side sections (if necessary)
When installing more than one Caséta Wireless in-wall dimmer in the same wallbox, it is necessary to remove inner side sections prior to wiring. See image and chart below for more information.
Important note: Removing side sections reduces the in-wall dimmer’s maximum wattage rating. See the chart below for maximum wattage information.
Connect the Caséta Wireless in-wall dimmer
Mount the Caséta Wireless in-wall dimmer
Location 1
Attach the wallplate
Location 1
Remove existing switch from wall at Location 2
Location 2
Tag and disconnect wires from the switch
Location 2
Connect the wires
Location 2
Attach the wallplate bracket and Pico remote control
Location 2
Attach the wallplate
Location 2
Turn power on at circuit breaker
Location 1
Location 2
Pair additional remote controls
Repeat steps 17 and 18 to pair additional remote controls.
Schematic Diagram
Documents / Resources
 | LUTRON PD-6WCL Caseta Wireless In-Wall Dimmer with Pico Remote Control [pdf] User Guide PD-6WCL, Caseta Wireless In-Wall Dimmer with Pico Remote Control |
