LUTRON MA-R-MSC-AD 600-Watt Multi Location Accessory Dimmer-logo

LUTRON MA-R/MSC-AD 600-Watt Multi Location Accessory Dimmer

LUTRON MA-R-MSC-AD 600-Watt Multi Location Accessory Dimmer-product

Quick Install Guide

MA-R / MSC-AD 8.3 A
Does not work alone. Must be used with a Maestro dimmer. If using anything other than a MACL-153M, please see the installation guide for that dimmer.

Please read before installing

Maestro Companion Device

How-to videosLUTRON MA-R-MSC-AD 600-Watt Multi Location Accessory Dimmer-fig-1

lutron.com/MACL

Important Notes

  1. Install in accordance with all national and local electrical codes.
  2. When no “grounding means” exists in wallbox, the National Electrical Code (NEC®) allows a control to be installed as a replacement when a plastic faceplate with plastic fasteners is used, or the circuit is protected by a ground fault circuit interrupter (GFCI). Lutron wallplates meet this requirement. Cap or remove green wire before screwing control into wallbox.
  3. Protect the control from dust and dirt when painting or spackling the wall.
  4. Clean the companion device with a soft damp cloth only. Do not use any chemical cleaners. For more information, please see www.lutron.com/cleaning
  5. For indoor use only.
  6. For any 3-way / 4-way circuit, use only one Maestro dimmer (MACL-153M) with up to 9 companion devices.
  7. Maximum wire length between the main control and the farthest accessory switch is 150 ft (45 m).

Disconnect Power

WARNING: SHOCK HAZARD. May result in Serious Injury or Death. Turn off power at circuit breaker or fuse before installing.LUTRON MA-R-MSC-AD 600-Watt Multi Location Accessory Dimmer-fig-2

3-Way Wiring with MACL-153M Dimmer

IMPORTANT: Before disconnecting the existing devices, tag the wire connected to the different colored screw (typically black, but wire colors vary, and labeled COM). This is the Common wire.
QUESTIONS? See www.lutron.com/MACLUTRON MA-R-MSC-AD 600-Watt Multi Location Accessory Dimmer-fig-3

4-Way Wiring with MACL-153M Dimmer

NOTE: Before disconnecting wires of existing devices, please tag wires as described above for 3-way wiring.LUTRON MA-R-MSC-AD 600-Watt Multi Location Accessory Dimmer-fig-4

Operation

IF LIGHTS ARE OFF: Single tap T for preset. Double tap T for full brightness.

IF LIGHTS ARE ON: Double tap T for full brightness. Single tap T to turn off. Press and hold T for delayed fade-to-off.LUTRON MA-R-MSC-AD 600-Watt Multi Location Accessory Dimmer-fig-5

TroubleshootingLUTRON MA-R-MSC-AD 600-Watt Multi Location Accessory Dimmer-fig-6

For more information, please visit www.lutron.com/MACL

LUTRON MA-R-MSC-AD 600-Watt Multi Location Accessory Dimmer-fig-7

Limited Warranty

www.lutron.com
TechnicalDocumentLibrary
369-119_Wallbox_Warranty.pdf ©2022 Lutron Electronics Co.,
Inc. Lutron and Maestro are trademarks or registered trademarks of Lutron Electronics Co.,
Inc., in the U.S. and other countries.
The YouTube icon is a trademark of Google LLC.
24/7
Support: 1.844.LUTRON1 (USA / Canada)
+1.888.235.2910 (Mexico)
www.lutron.com/MACL

Documents / Resources

LUTRON MA-R/MSC-AD 600-Watt Multi Location Accessory Dimmer [pdf] Installation Guide
MA-R MSC-AD 600-Watt Multi Location Accessory Dimmer, MA-R MSC-AD, 600-Watt Multi Location Accessory Dimmer, Location Accessory Dimmer

References

Leave a comment

Your email address will not be published. Required fields are marked *