Lumens OIP-N40E, OIP-N60D AV-H Bridge
Product connection
- OIP-N40E supports PoE (IEEE 802.3af) network switches or USB-C power supply
Instruction for Installation
Using the accessory metal plates
- Lock the accessory metal plate with screws (M3 x 4) to the lock holes on both sides of the OIP-N40E
- Install the metal plate and OIP-N40E under the table according to the spatial area
- Use tripod The camera can be mounted on a 1/4″-20 LINC P TZ tripod deck by using the lock holes on the side for the tripod of OIP- N60D
OIP-N40E Operation Methods
Operate through the body button
Connect the HDMI OUT to the display, press the Menu dial to enter the OSD menu. Through the Menu dial to navigate the menu and adjust the parameters 
- Left/Right rotation: Adjust parameters and navigate the menu
- Press: Perform “confirm” action
- Operate via webpages
Confirm the IP address
Refer to Operate through the body button, confirm the IP address in Status (If the OIP- N40E is directly connected to the computer, the default IP is 192.168.100.100. You need to manually set the computer’s IP address in the same network segment.) 
- Open the browser and input the IP address, e.g. 192.168.4.147, to access the login interface.
- Please enter the account/password to log in
HDMI Signal Source Transmission Network
Connection Method
- Connect the signal source device to the OIP-N40E’s HDMI or USB-C input port using HDMI or USB-C cable
- Connect the OIP-N40E and computer to the network switch using network cable
- Connect the HDMI signal to HDMI IN, and the signal can be captured and synchronized to the display (pass-through)
Webpage Settings
[ Stream ] > [ Source ] Select the output signal > [ Stream Type ] Set the stream type > [ Apply ] Apply
Streaming Output
Open streaming media platforms such as VLC, OBS, NDI Studio Monitor, etc., for streaming output
USB Network Camera Extension (OIP-N60D Required)
When used with the OIP-N40E and OIP-N60E, it can extend the range of USB cameras through the network to improve installation flexibility.
Connection Method
- Connect the OIP-N40E/N60D to the local network
- Connect the USB camera to the OIP-N60 Dusing a USB-A cable
- Connect the monitor to the OIP-N60D using an HDMI cable
- Connect the computer to the OIP-N40E using a USB-C cable
Note
- Computers can use USB-C to connect to the OIP-N40E and use a USB network camera
- Computers can project images onto a TV through a USB-C connection to OIP-N40E
OIP-N60D Webpage Settings
- [ System ] > [ Output ], open [ USB Extender ]
OIP-N40E Webpage Settings
- [ System ] > [ Output ] > [ Extender Source List ]
- [ Search new Source ] > Click [ Available ] to select the OIP-N60D > Connection displays Connected
USB Camera Screen Output
- Launch a video software like Skype, Zoom, Microsoft Teams, or other similar software
- Choose the video source, to output USB camera images
- Video Source Name: Select according to the USB Camera ID
For questions about the installation, please scan the QR Code. A support person will be assigned to assist you. 
Frequently Asked Questions
Q: How do I get assistance with installation issues?
A: For installation questions, please scan the QR Code provided. A support person will be assigned to assist you.
Documents / Resources
 | Lumens OIP-N40E, OIP-N60D AV-H Bridge [pdf] Installation Guide OIP-N40E, OIP-N60D, OIP-N40E OIP-N60D AV-H Bridge, OIP-N40E OIP-N60D, AV-H Bridge, Bridge |