Lume cube LC01 Studio Panel 2 Sided Card Stock

LC01 Studio Panel 2 Sided Card Stock

For setup instructions, product information, and to register your 12-month warranty, use the camera on your smartphone to scan the QR
QR-Code

Studio Panel Remote

Remote-Control-Overview

  1. LED Indicator
  2. Power Button
  3. Channel Button
  4. Brightness Adjustment + /-
  5. Color Temp Adjustment +/-
  6. Selector
  7. 3200K Color Temp Button
  8. 5600K Color Temp Button
  9. 50% Brightness Button
  10. 25% Brightness Button
  11. 100% Brightness Button

Studio Panel

LC01 Studio Panel 2 Sided Card Stock Overview

  1. LCD Screen
  2. Power Switch
  3. Brightness Dial
  4. Color Temperature Dial
  5. AC Power Port
  6. 1/4″ 20 Mount
  7. Camera Mount
  8. Brightness Level
  9. Battery Remaining
  10. Color Temperature
  11. Frequency Channel

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Lume cube -Logo.png

Documents / Resources

Lume cube LC01 Studio Panel 2 Sided Card Stock [pdf] User Guide
LC01, 2A792-LC01, 2A792LC01, LC01 Studio Panel 2 Sided Card Stock, Studio Panel, 2 Sided Card Stock, Studio Panel 2 Sided Card Stock

Leave a comment

Your email address will not be published.