Document
luceco ECT6W8S40-01 LED Eco Climate T8 
Tube Instruction Manual

luceco ECT6W8S40-01 LED Eco Climate T8 Tube Instruction Manual

ACCESSORIES:

luceco ECT6W8S40-01 LED Eco Climate T8 Tube Instruction Manual - Accessories

This luminaire is made from polycarbonate with polycarbonate clips. Ensure product is suitable for installation area.

This Luminaire is suitable for use in temperature of -10°C to +40°C.

Surface mounted only.
Disconnect the power supply before installation.

  1. Fix plastic retainer clips to bottom fitting housing.
    luceco ECT6W8S40-01 LED Eco Climate T8 Tube Instruction Manual - Fix plastic retainer clips to bottom fitting housing
  2. Remove gear tray by rotating holders or releasing fixing clips. Lift to remove.
  3. Fix lamp holders from the rear of the gear tray [the two wired to the terminal block and the two included in the accessories pack to be installed at opposite ends.
  4. Drill the fixing holes at suitable place for installation [wall/ ceiling] fix the body to the fixing clips.
    luceco ECT6W8S40-01 LED Eco Climate T8 Tube Instruction Manual - Drill the fixing holes at suitable place
  5. Fit cable gland and suitable cable through gland entry at end of the base. Ensure hole is removed of burrs to ensure I P65 seal.
    luceco ECT6W8S40-01 LED Eco Climate T8 Tube Instruction Manual - Fit cable gland and suitable cable through gland
  6. Connect to 3way terminal block on the underside of the gear tray, ensure correct polarity.
    luceco ECT6W8S40-01 LED Eco Climate T8 Tube Instruction Manual - Connect to 3way terminal block on the underside
  7. Refit gear tray, and ensure secure, refit T8 LED tubes and rotate.
    luceco ECT6W8S40-01 LED Eco Climate T8 Tube Instruction Manual - Refit gear tray
    Note – ensure powered end of tube, is inserted into correct end, with powered lamp holders.
  8. Refit diffuser and secure all clips.
    luceco ECT6W8S40-01 LED Eco Climate T8 Tube Instruction Manual - Refit diffuser and secure all clips
  9. Re-initiate power and operate as required.

ADDITIONAL INFORMATION – COMPONENT REPLACEMENT

  1. product is fitted with single ended Luceco LED TS tubes.
    When replacing tubes, ensure they are replaced with Luceco LED TS tubes.

United Kingdom Warranty
For other territories and for further information, please see www.luceco.uk for details.

Products are protected for a period of 2 years warranty from date of purchase against defects in material and workmanship (unless otherwise stated). Should a product fail to perform as described within the warranty period it will be repaired or replaced with the same or equivalent product by Luceco, free of charge provided that you: (1 I return the product to us with shipping charge prepaid, (2) provide us with proof of the original date of purchase and (3) quote our return authorization number.

Repaired or replaced products will be returned to you with shipping charges prepaid. Replacement products may be refurbished or contain refurbished materials. If in our sole discretion, we are unable to repair or replace a defective product, we will refund the purchase price of the product. This warranty will not apply if in our judgment, the product fails due to damage in shipment, handling, storage, accident, abuse or misuse, or if it has been used in a manner not conforming to our product instructions, has been modified in any way, or has any serial number removed or defaced. Repair or attempted repair will void this warranty. Our maximum liability under the terms of this warranty is limited to the purchase price of the product covered by the warranty. The warranty is given under English Law. If any part of this warranty is deemed unenforceable (including any provision in which we exclude our liability to you) the enforceability of any other parts of the warranty will not be affected. These terms do not reduce your statutory rights. For Non-UK please contact Local Luceco Office for details. THESE TERMS AND CONDITIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.

Eventually, you may want to replace this fitting;
Environmental Protection W.E.E.E (Wheelie Bin Symbol for EU ONLY) This symbol is known as the “crossed-out” wheelie Bin Symbol”. When this symbol is marked on a product or battery, It means that it should not be disposed of with your general household waste. Some chemicals contained within electrical Electronic products or batteries can be harmful to health and the environment. Only dispose of electrical/electronic/battery items in separate collection schemes, which cater for the recovery and recycling of materials contained within. Your co-operation is vital to ensure the success of these schemes and for the protection of the environment.

Tech Help Line
UK – 0330 0249 279
Non UK – +44 (0)1952 238 100
Supplied by LUC ECO
Stafford Park 1, Telford, Shropshire,
England, TF3 3BD
Visit our website at www.luceco.com

Kontakt
UK – 0330 0249 279
Non UK – +49 40 89066 878 – 29 (Fax)
Geliefert von Luceco GmbH
Holstenplatz 20b,
22765 Hamburg DEUTSCH LAND
Besuchen Sie uns auf www.luceco.de

Support Technique
UK- 0330 0249 279
Non UK- +33 (0)1611010 35
Notice fournie par
Luceco SAS France & Belux 3
Rue de Courtalin, Magny Le Hong re 77700
FRANCE & BE LUX
Visitez note site Web www.luceco.fr

Servicio de asistencia telef6nica
UK – 0330 0249 279
Non UK – +34 93 829 55 74
IEU) Luceco SE
C/ Bobinadora 1-5 08302 Matar6
Barcelona Spain
Visite nuestra web en www.luceco.com

Assistenza tecnica telefonica
UK – 0330 0249 279
Non UK – +39 0434 1696795
Fornito da BG Electrical Ltd Nexus
Italia, Via Amman 10 33170
Pordenone, Italy
Visitate il nostro sito www.luceco.com

Documents / Resources

luceco ECT6W8S40-01 LED Eco Climate T8 Tube [pdf] Instruction Manual
ECT6W8S40-01, LED Eco Climate T8 Tube, ECT6W8S40-01 LED Eco Climate T8 Tube

Leave a comment

Your email address will not be published.