LG Air Conditioner Remote Control Manual

LG-Air-Conditioner-Remote-ControlLG Air Conditioner Remote

For a full instruction guide on the LG air conditioner and remote, please check this guide:

LG Wall-Mounted Air Conditioner Instructions and Remote Button Help

Using Wireless Remote Control

You can operate the air conditioner more conveniently with the remote control.
LG-Air-Conditioner-Remote-Control-Using Wireless Remote Control

LG-Air-Conditioner-Remote-Control-conveniently with the remote control

LG-Air-Conditioner-Remote-Control-conveniently with the remote control 2

NOTE: Some functions may not be supported, depending on the model.• •* buttons may be changed according to the type of model.• •Press the SET/CANCEL button to operate the selected FUNC.

Restarting the Air Conditioner Automatically

When the air conditioner is turned on again after a power failure, this function restores the previous settings.

Disabling Auto Restart

  1. Open the front cover (Type2) or horizontal vane (Type1).
  2. Press the ON/OFF button and hold it for 6 seconds, then the unit will beep twice and the lamp will blink twice 4 times.•
    • To re-enable the function, press the ON/OFF button and hold it for 6 seconds. The unit will beep twice and the lamp will blink 4 times.



  • The feature may be changed according to the type of model.
  • If you press and hold the ON/OFF button for 3 – 5 seconds, instead of 6 seconds, the unit will switch to the test operation.
  • In the test operation, the unit blows out strong cooling air for 18 minutes and then returns to factory default settings.

Using the Mode Function
This function allows you to select the desired function.

Cooling Only Model

LG-Air-Conditioner-Remote-Control-Cooling Only Model

Cooling Mode
  1. Turn the appliance on.
  2. Press MODE button repeatedly to select the Cooling Mode is displayed on the display screen.
  3. Press or button to set the desired temperature.

LG-Air-Conditioner-Remote-Control-Heating Mode

LG-Air-Conditioner-Remote-Control-Fan Mode

LG-Air-Conditioner-Remote-Control-ENAuto Operation (Artificial Intelligence)

LG-Air-Conditioner-Remote-Control-Using the Jet Mode Function

Using the Fan Speed Function

LG-Air-Conditioner-Remote-Control-Using the Fan Speed Function

Using the Air Flow Direction Function
LG-Air-Conditioner-Remote-Control-Using the Air Flow Direction Function


The following safety guidelines are intended to prevent unforeseen risks or damage from unsafe or incorrect operation of the appliance.
The guidelines are separated into ‘WARNING’ and ‘CAUTION’ as described below.

Warning Icon This symbol is displayed to indicate matters and operations that can cause risk. Read the part with this symbol carefully and follow the instructions in order to avoid risk.
Warning Icon WARNING
This indicates that the failure to follow the instructions can cause serious injury or death.
Warning Icon CAUTION
This indicates that the failure to follow the instructions can cause the minor injury or damage to the product.

Warning Icon WARNING
To reduce the risk of explosion, fire, death, electric shock, injury or scalding to persons when using this product, follow basic precautions, including the following:
Children in the Household
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.


  • Do not install the air conditioner on an unstable surface or in a place where there is danger of it falling.
  • Contact an authorized service center when installing or relocating the air conditioner.
  • Install the panel and the cover of the control box safely.
  • Do not install the air conditioner in a place where flammable liquids or gases such as gasoline, propane, paint thinner, etc., are stored.
  • Make sure that the pipe and the power cable connecting the indoor and outdoor units are not pulled too tight when installing the air conditioner.
  • Use standard circuit breaker and fuse that conform to the rating of the air conditioner.
  • Do not input air or gas into the system except with the specific refrigerant.
  • Use non-flammable gas (nitrogen) to check for leak and to purge air; using compressed air or flammable gas may cause fire or explosion.
  • The indoor/outdoor wiring connections must be secured tightly, and the cable should be routed properly so that there is no force pulling the cable from the connection terminals. Improper or loose connections can cause heat generation or fire.
  • Install a dedicated electric outlet and circuit breaker before using the air conditioner.
  • Do not connect the ground wire to a gas pipe, a lightning rod, or a telephone ground wire.


  • Be sure to use only those parts listed in the service parts list. Never attempt to modify the equipment.
  • Make sure that children do not climb on or hit the outdoor unit.
  • Dispose of the batteries in a place where there is no danger of fire.
  • Use only the refrigerant specified on the air conditioner label.
  • Cut off the power supply if there is any noise, smell, or smoke coming from the air conditioner.
  • Do not leave flammable substances such as gasoline, benzene, or thinner near the air conditioner.
  • Contact an authorized service center when the air conditioner is submerged by flood waters.
  • Do not use the air conditioner for an extended period of time in a small place without proper ventilation.
  • In the event of a gas leak (such as Freon, propane gas, LP gas, etc.) ventilate sufficiently before using the air conditioner again.
  • To clean the interior, contact an authorized service center or dealer.
  • Using harsh detergents may cause corrosion or damage to the unit.
  • Be sure to ventilate sufficiently when the air conditioner and a heating appliance such as a heater are used simultaneously
  • Do not block the inlet or outlet of air flow.
  • Do not insert hands or other objects through the air inlet or outlet while the air conditioner is operating.
  • Make sure that the power cable is neither dirty, loose, nor broken.
  • Never touch, operate, or repair the air conditioner with wet hands.
  • Do not place any objects on the power cable.
  • Do not place a heater or other heating appliances near the powercable.
  • Do not modify or extend the power cable. Scratches or peeling insulation on the power cables may result in fire or electric shock, and should be replaced.
  • Cut off the power supply immediately in the event of a blackout or a thunderstorm.
  • Take care to ensure that power cable could not be pulled out or damaged during operation.
  • Do not touch refrigerant pipe or water pipe or any internal parts while the unit is operation or immediately after operation.


  • Do not clean the appliance by spraying water directly onto the product.
  • Before cleaning or performing maintenance, disconnect the power supply and wait until the fan stops.

Technical Safety

  • Installation or repairs made by unauthorized persons can pose hazards to you and others.
  • The information contained in the manual is intended for use by a qualified service technician who is familiar with the safety procedures and equipped with the proper tools and test instruments.
  • Failure to read and follow all instructions in this manual can result in equipment malfunction, property damage, personal injury and/or death.
  • The appliance shall be installed in accordance with national wiring regulations.
  • When the power cord is to be replaced, the replacement work shall be performed by authorized personnel using only genuine replacement parts.
  • This appliance must be properly grounded to minimize risk of electric shock.
  • Do not cut or remove the grounding prong from the power plug.
  • Attaching the adapter ground terminal to the wall receptacle cover screw does not ground the appliance unless the cover screw is metal, uninsulated, and the wall receptacle is grounded through house wiring.
  • If you have any doubt whether the air conditioner is properly grounded, have the wall receptacle and circuit checked by a qualified electrician.
  • The refrigerant and insulation blowing gas used in the appliance require special disposal procedures. Consult a service agent or a similarly qualified person before disposing of them.
  • If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly qualified person in order to avoid a hazard.

Warning IconCAUTION
To reduce the risk of minor injury to persons, malfunction, or damage to the product or property when using this product, follow basic precautions, including the following:

  • Do not install the air conditioner in an area where it is directly exposed to sea wind (salt spray).
  • Install the drain hose properly for the smooth drainage of water condensation.
  • Exercise caution when unpacking or installing the air conditioner.
  • Do not touch the leaking refrigerant during installation or repair.
  • Transport the air conditioner with two or more people or use a forklift.
  • Install the outdoor unit such that it is protected from direct sunlight.
  • Do not place the indoor unit in a place where it is directly exposed to sunlight via the windows.
  • Safely dispose of packing materials such as screws, nails or batteries using proper packaging after installation or repair.
  • Install the air conditioner in a place where the noise from the outdoor unit or the exhaust fumes will not inconvenience the neighbors. Failure to do so may result in conflict with the neighbors.
  • Remove the batteries if the remote control is not to be used for an extended period of time.
  • Make sure that the filter is installed before operating the air conditioner.
  • Be sure to check if there is a refrigerant leak after installing or repairing the air conditioner.
  • Do not place any object on the air conditioner.
  • Never mix different types of batteries, or old and new batteries for the remote control.
  • Do not let the air conditioner run for a long time when humidity is very high or when a door or a window has been left open.
  • Stop using the remote control if there is a fluid leak in the battery. If your clothes or skin are exposed to the leaking battery fluid, wash off with clean water.
  • Do not expose people, animals, or plants to the cold or hot wind from the air conditioner for extended periods of time.
  • If the leaking battery fluid has been swallowed, wash off the inside of the mouth thoroughly and consult a doctor.
  • Do not drink the water drained from the air conditioner.
  • Do not use the product for special purposes, such as preserving foods, works of art, and etc. It is an air conditioner for consumer purposes, not a precision refrigeration system. There is risk of damage or loss of property.
  • Do not recharge or disassemble the batteries.
  • Never touch the metal parts of the air conditioner when removing the air filter.
  • Use a sturdy stool or ladder when cleaning, maintaining, or repairing the air conditioner at a height.
  • Never use strong cleaning agents or solvents when cleaning the air conditioner or spray water. Use a smooth cloth

Questions about your LG Air Conditioner Remote Control ? Post in the comments!

Other LG AIR Conditioners Manuals:

LG Air Conditioner Remote Control Manual
Click to Read More LG Manuals

Join the Conversation


  1. The unit turns off on it’s own and turns back on later and it gets very hot when it does this at night. How can I just get it to stay on all the time during the night and thank you for helping.

  2. In HEAT mode the unit switches on and the outside compressor unit fans run but the unit does not blow hot air around the room. The indoor unit fan sometimes starts but then quickly switches off.

    On the indicator panel has a light in the middle of the panel that stays on. For the fan on the indoors unit to run this light goes off. This light only goes off for a few seconds in heat mode.
    The heat temperature is set maximum 30C and the room temperature well below that at 15C.

  3. we have recently installed new LG AC. but it is not cooling. even after pressing JET Mode after few seconds it goes back to its normal temperature. on the screen it shows 20d but the room temperature remains the same 28-30d. i also tried the step of cooling only mode, there it shows A1, but when i try to set to 2, it again goes back to A1. So, i don’t understand what is the problem.
    Its really very difficult to stay in this weather without the AC, specially when you have children. your prompt assistance is highly appreciated.

  4. Hi, is there a way to activate back-light for the remote control’s display? At night it’s really difficult to operate tje remote

  5. My dual inverter AC won’t respond to the remote controller. I have changed batteries on the remote controller and even did a hard reset but it won’t respond to the remote controller. any advise?

  6. When I turn on the AC system, CH and 23 appear and it doesn’t work. What should I do?
    Cuando prendo el sistemas de AC aparece CH y 23 y no funciona. Que debo hacer?

  7. Can someone please tell me how to turn on the heat? I would love a picture of what the settings should look like. I’m feeling old fashioned – I like these units, but I sure would appreciate a “cool” and “heat” function. All these icons are like a new language to me, and the directions posted on this site are not good. By following them, I’ve not been able to turn on one of the 12 units we have.

    1. Use the mode button.. with the sun on it…think it is the 4th option..1st is cooling 2nd is auto change 3rd is dehumidify 4th is heat.
      set the temperature, and away you go

  8. Hello
    My dual-energy device has a problem.

    I put the temperature on 22 and it goes up to 25-26.
    I can move the remote around and put it in front of the device so that it can feel the heat and stop on its own but nothing to do.

    Can you help me please
    Mon appareil bi-énergie a un problème.

    Je met la température la 22 et sa monte jusqu’à 25-26.
    J’ai beau déplacer la télécommande de place et la mettre devant l’appareil pour qu’elle puisse sentir la chaleur et arrêter par elle même mais rien à faire.

    Pouvez-vous m’aider svp

Leave a comment

Your email address will not be published.