Lezyne LZ7 Micro LED Light User Manual

User Manual

READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new Lezyne LED light. Traffic laws mandating lighting vary from country to country. Inform yourself about lighting laws in the country of use.

Lezyne LZ7 Micro LED Light

Warnings

DO NOT LOOK DIRECTLY INTO LIGHT BEAM or shine into eyes of another.

DO NOT SUBMERGE UNDERWATER. Lezyne LED lights are water-resistant under normal conditions but are not waterproof. If moisture gets inside the light body, remove tailcap and air-out until completely dry.

DO NOT ATTEMPT TO REMOVE ELECTRONICS. Doing so will void the warranty.

Lezyne USA Inc. and Lezyne Co., Ltd. do not accept any liability for injuries or other damages resulting from the use of this product in any circumstances.

Warranty

In U.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the original purchase date to the original owner (proof of purchase is required). Lezyne Batteries carry a six (6) month warranty from the original purchase date. Lezyne warranties cover any manufacturing defects in materials or workmanship. Issues not covered by warranty include normal wear & tear, improper installation, attempting to access or modify electronics, damage or failure due to accident, misuse,  abuse, and/or neglect. For warranty issues outside of the United States, contact the distributor/retailer for your country or region directly. To find a distributor near you, visit: http://lezyne.com/contact/distributors

Mounting

FRONT: center light in clamp, do not clamp by tailcap.

Lezyne LZ7 Micro LED Light - Mounting

REAR: ensure tail cap groove is fully engaged in clamp.

Operation

1. On/Off: hold button two (2) sec.
2. Mode cycle: click button
3. Overdrive Race Mode/Daytime Flash: hold button five (5) sec.

OVERDRIVE RACE MODE (front only): With the light, OFF, hold the button for five (5) seconds, until light flashes. The light is now in Overdrive Race Mode where only Overdrive and Economy outputs are selectable. The light will remain in Overdrive Race Mode even when switched OFF. Repeat the step above to return to the normal mode set.
DAYTIME FLASH (rear only): With the light, off, press and hold the power button for five (5) seconds, until the light flashes. The light will now enter a brighter flash mode for daytime riding. Once turned off the light will return to normal.

THERMAL PROTECTION: If the operating temperature of the light is too high, the light automatically lowers the lumen output.

Run Times and Modes

Lezyne LZ7 Micro LED Light - Run Times and Modes

Battery Indicator

Green and red LEDs, located in the button, display the current battery status while the light is ON. When the light is OFF, click the button once to display the current battery status for two (2) seconds.

Lezyne LZ7 Micro LED Light - Battery Indicator

Charging

Before using your Lezyne LED Light for the first time, fully charge a battery.
To charge your light:

  1. Switch light OFF
  2. Unscrew tail cap
  3. Insert USB plug into the powered USB port
  4. Once charging, the button will flash green
    If button does not flash when plugged in, a selected USB port may not be powered—try another USB port.
    Light will be charged after 3–4 hours or when the button is solid green.
  5. Remove light from the charger and reinstall tail cap—ensure tail cap is fully installed for water resistance

Lezyne LZ7 Micro LED Light - Battery Indicator

More Information

For more information on Lezyne products, visit: http://lezyne.com

Lezyne LZ7 Micro LED Light User Manual – Download [optimized]
Lezyne LZ7 Micro LED Light User Manual – Download

Leave a comment

Your email address will not be published. Required fields are marked *