TTA-080SI Official Lenco Webshop
Product Information
Specifications
- Model: TTA-080SI / TTA-180TN
- Function: Lighting effect adjustment
- Gain Levels: 1, 2, 3, 4, 5
- LED Indications: Red, Blue, White, Pink, Green.
Frequently Asked Questions
Q: Can the gain levels be adjusted while the device is in use?
A: Yes, you can adjust the gain levels while the device is in use by following the instructions provided in the manual.
Q: What should I do if all LEDs flash for 5 seconds?
A: If all LEDs flash for 5 seconds, it indicates a low battery level. Please recharge or replace the batteries as needed.
Operation instruction to adjust the lighting effect
To adjust the microphone input’s gain/sensitivity for driving the flash lighting and effects (refer to the corresponding table for detail), follow the steps below:
- Power On: Long press the “ON/OFF” button to power on the device;
- Enter Gain Adjustment Mode: While the device is powered on, quickly short press the “ON/OFF” button twice to enter [Gain Adjustment] mode;
- Adjust Gain: In [Gain Adjustment] mode, short press the “ON/OFF” button once, or repeatedly, to adjust the light’s gain to the desired level. There are 5 gain levels (1, 2, 3, 4, and 5) available for selection;
- Exit Gain Adjustment Mode: Once the adjustment is complete, quickly short-press the “ON/OFF” button twice to exit [Gain Adjustment] mode. Alternatively, the mode will exit automatically after 30 seconds of inactivity.
Note:
- The corresponding light flashing depends on the gear number (1 – 5) of gain level, higher the number will be the higher the sensitivity = more reaction to music beats
- The default gain level of the software is set at gear 3
Mic Gain/Sensitivity Adjustment for Driving Light Effects
Corresponding table
| Gear Mode Selection | LED Indication | Gain/Sensitivity Level |
| 1 | Red LED light up | lowest |
| 2 | Blue LED light-up | lower |
| 3 (Factory Default) | White LED light-up | Medium sensitivity |
| 4 | Pink LED light-up | higher |
| 5 | Green LED light-up | highest |
Low battery
- When the battery voltage drops to low level, all 5 LEDs will flash 5 seconds.
- When the battery voltage drops to the lowest level, all 5 LEDs will flash for 5 seconds and then the device will power off.
Remark: this device can also be used without a turntable and will light like a disco ball but will not rotate.
Documents / Resources
 |
Lenco TTA-080SI Official Lenco Webshop [pdf] Instruction Manual TTA-080SI, TTA-180TN, TTA-080SI Official Lenco Webshop, TTA-080SI, Official Lenco Webshop, Lenco Webshop, Webshop |