XTOOL J2534 XVCI Max Programming Master of OEM Software Tool Device User Guide
Open the XVCI Maх software
XVCI Max management software has been installed in our company’s products.
Connect the XVCI Maх device
Before using the device, the hardware must be correctly connected. The vehicle end is connected to the vehicle through the OBD-II diagnostic cable, and the PC end is connected to the PC through the USB
XVCI Max device connection diagram
Install the OEM driver
Click the [Vehicle Diagnosis] tab of the XVCI Max software, and then click [My Application] on the left side of the page, where the authorizations that the customer has are displayed. Click “JLR SDD”, the driver installation interface will pop up: click [Install]. If the JLR SDD driver has been installed in the JLR-SDD system, if there is a JLRSDD driver update, click [Update] here to update
JLR SDD driver installation is complete, click [close] to complete the installation
Start the OEM diagnostic software
Click the [Vehicle Diagnosis] tab of the XVCI Max software, then click [My Application] on the left side of the page, click [JLR SDD], in the pop-up dialog box, click [Operation] to start JLR SDD diagnosis program.
Documents / Resources
 | XTOOL J2534 XVCI Max Programming Master of OEM Software Tool Device [pdf] User Guide J2534, XVCI Max Programming Master of OEM Software Tool Device |
