speco technologies SGBRIDGE1TB Cloud Bridge with SecureGuard Remote Web Browser Access

Discovering and Logging into SGBRIDGE

• Connect both power and a network connection with internet access to your SGBRIDGE*.
  • *The SGBRIDGE’s network ports are configured to DHCP by default. If a static address is needed, you will need to connect a keyboard, mouse, and monitor to the bridge hardware.
• While the SGBRIDGE is booting, connect your laptop to the same network the SGBRIDGE is on.
• Download, install, and open the Speco Scanner application. This application will search for your SGBRDIGE. Double-click to access the web setup.
• Your default web browser will open a login screen. The default login credentials are:
  • Username: admin
  • Password: admin
• Click ‘Submit’ to proceed.

Adding sites to SGBRIDGE

• After logging in, click the hamburger menu on the upper left corner of the interface.
• Click ‘Config’.
• Click ‘Site Locate’
• Find the device(s) you’d like to add to your SGBRIDGE and click the ‘+’ in their row.
• Enter the correct credentials of the device and click ‘Check Site’
• If successful, a blue message will display stating the ‘Check Site’ was successful and channels have been received. Click the ‘x’ icon of the blue message.
• For recorders, select the channels that you want to go to the cloud. Then click ‘Submit’
• Click ‘Close’ in the Site Locate interface.
• You will then need to perform a restart for the device(s) to be added. Click ‘System Config’.
• Click ‘Restart SecureGuard’
• Click ‘Restart’.
• You will be notified that SecureGuard will be restarted and that you’ll need to refresh the web browser page. When you refresh, you’ll have to log in again.
• Log into the web interface again.
• Navigate to the Site Config interface and you’ll see your recorder information.

Configuring Channels for Cloud Use

• In the web setup, go to ‘Camera Config’. It will take a few seconds for the parameters to come through. Once displayed, ensure that both main and substream ‘Encoding’ settings are H.264. Configure Resolution, Frame Rate, and Bit-Rate accordingly.
• Once completed entering the parameters, click ‘Submit’.

Information for Adding SGBRIDGE to the Cloud

• Once you’ve completed your camera configuration, click ‘System Config’ and note the Cloud ID and Cloud Password. You can see the Cloud Password by clicking the eyeball icon.
• You can open another tab for the Cloud Portal setup so that you can copy and paste the Cloud information.
• Please view the Partner Portal Quick Setup Guide to learn how to add and set up an SGBRIDGE for a customer.

Documents / Resources

speco technologies SGBRIDGE1TB Cloud Bridge with SecureGuard Remote Web Browser Access [pdf] User Guide SGBRIDGE1TB Cloud Bridge with SecureGuard Remote Web Browser Access, SGBRIDGE1TB, Cloud Bridge with SecureGuard Remote Web Browser Access, SecureGuard Remote Web Browser Access, Remote Web Browser Access, Web Browser Access, Browser Access

References

• User Manual