infineon XENSIV Sensor Shield Kit
Product Usage Instructions
- Connecting the Sensor Shield:
- Insert the XENSIV sensor shield onto the supported baseboard of your choice following the pinout details provided in the manual.
- Powering Up:
- Ensure the baseboard is powered on and providing the necessary power supply to the sensor shield.
- Interfacing with Sensors:
- Utilize the respective pins and interfaces on the sensor shield to interact with the different sensors included in the kit.
- Data Processing:
- Implement appropriate data processing algorithms to interpret the sensor readings obtained from the various sensors on the shield.
Kit Features
- XENSIV TM 60GHz Radar sensor (BGT60LTR11AIP)
- XENSIV TM digital barometric pressure sensor with built-in temperature sensor (DPS368)
- Two high-performance XENSIV TM MEMS digital microphones (IM72D128)
- XENSIV TM PAS CO2 sensor based on photo acoustic spectroscopy principle(PAS CO2)
- OPTIGATM Trust M security controller (SLS32AIA010MK)
- Digital humidity and temperature sensor
- Six-axis inertial measurement unit
- Three-axis magnetometer sensor
- SPI-based TFT display
- Headers compatible with Arduino UNO R3
OVERVIEW
SHIELD_XENSIV_A XENSIV TM sensor shield details
- XENSIVTM digital barometric air pressure sensor with built-in temperature sensor (U2)
- I2C interface connector (J16)
- External Radar shield interface connectors (J5, J15)
- XENSIVTM 60 GHz Radar sensor (U1)
- Radar sensor status LEDs (D1, D2)
- Six-axis inertial measurement unit (U14)
- USB connector-based auxiliary power supply for Radar subsystem (J11)
- Digital humidity and temperature sensor (U17)
- Power header compatible with Arduino UNO R3 (J1)
- Three-axis magnetometer sensor (U13)
- I/O headers compatible with Arduino UNO R3 (J2, J3, J4)
- XENSIV™ PAS CO2 sensor (U3)
- SPI-based TFT display (DISP1)
- Two high-performance XENSIVTM MEMS digital microphones (U4, U5)
- I2C and RESET selection switch (SW1)
- Interrupt selection switch (SW2)
- OPTIGATM Trust M security controller (U6)
- I2C selection switch (SW3)
Sensor shield pinout details
SHIELD_XENSIV_A XENSIV TM sensor shield pinout details
Get started with the XENSIV sensor shield and supported baseboard of your choice. Refer to Kit guide at www.infineon.com/XSS-UG.
MORE INFORMATION
- Published by Infineon Technologies AG
- 81726 Munich, Germany
- All rights reserved. © 2024
- Infineon Technologies AG
- www.infineon.com/SHIELD_XENSIV_A
FAQs
- Q: Where can I find more detailed information on using the XENSIV sensor shield?
- A: Refer to the Kit guide at www.infineon.com/XSS-UG for comprehensive instructions on utilizing the sensor shield with different baseboards.
Documents / Resources
 | infineon XENSIV Sensor Shield Kit [pdf] User Guide XENSIV Sensor Shield Kit, Sensor Shield Kit, Shield Kit |