idatalink RSPDIF Analog to SPDIF Audio Converter
MAESTRO RSPDIF INSTALLATION GUIDE
PART NUMBER:ACC-RR-SPDIF
The RSPDIF adapter is used to convert analog audio input signals into SPDIF digital outputs to provide input to factory amplifiers that require this type of input. It can installed as part of a Maestro radio replacement solution with the associated T-harness or used stand alone with another radio replacement interface. It features di p switches for the input signal voltage and bitrates for the SPDIF output.
WIRING THE RSPDIF AS PART OF A MAESTRO RADIO REPLACEMENT SOLUTION – MAESTRO RR/RR2 AND T-HARNESS
WIRING THE RSPDIF FOR USE WITH ANOTHER INTERFACE SOLUTION
SETTING THE DIP SWITCHES
INPUT LEVEL SELECTION
Set the input level selection switch to match the pre-out voltage of the aftermarket radio.
SETTING THE BIT RATE
Choose the appropriate bit rate switch to 44.1 kHz or 48kHz to match the amplifier input. This will be specified in the installation guide for a Maestro radio replacement solution.
Some common applications are:
Honda – 44.1 kHz
Hyundai/Kia – 48kHz
Documents / Resources
 | idatalink RSPDIF Analog to SPDIF Audio Converter [pdf] Installation Guide 794RRSPDIF, ACC-RR-SPDIF, RSPDIF Analog to SPDIF Audio Converter, Analog to SPDIF Audio Converter, SPDIF Audio Converter, Audio Converter |
