LAOTIE logo

User Manual 
ES19 Electric scooter

Product Introduction

Product Overview

LAOTIE Electric Scooter -overview

Main Part Introduction
  1. Front light button
  2. Turn signal button
  3. Horn button
  4. Volt lock with key
  5. Smart display (with USB port)
  6. Power button
  7. Mode button
  8. Accelerator
  9. Speed limit button
  10. Single / Dual engine button

LAOTIE Electric Scooter -main part

Folding Instructions

  1. Press the button on the rod to lower the position
  2. Rotate the outer ring of the handle
  3. Fold the handle
  4. Pull out the red rod
  5. Press sliver rod to lower the scooter
  6. Done

LAOTIE Electric Scooter - folding

Charge your scooter

LAOTIE Electric Scooter -open LAOTIE Electric Scooter -plug LAOTIE Electric Scooter -cherging
Open the rubber flap Plug the power adapter into the charging port When  charging is completed, put back the rubber flag

Safety Instructions

  • Persons without excellent vision, balance, coordination, reflex, muscle and bone strength, and good decision-making capabilities should not use this product.
  • The user of this product assumes ALL risks associated with its To minimize these RISKS, the user must wear a safety helmet, goggles, gloves, elbow and kneepads, and appropriate footwear.
  • This manual contains important safety information. It is your responsibility to review this information and make sure that all riders understand all warnings, cautions, instructions, and safety. We’re not liable for incidental damages or consequential damages due directly or indirectly to the use of this product.
  • Riding the electric scooter can be hazardous Certain conditions may cause the equipment to fail without the fault of the manufacturer. Like other electric products, the scooter can and is intended to move and it is, therefore, possible to lose control, fall off and/or get into dangerous situations that no amount of care, instruction or expertise can eliminate. If such things occur you can be seriously injured or die, even when using safety equipment and other precautions. RIDE AT YOUR OWN RISK AND USE COMMON SENSE.

Always follow the local laws and regulations.

  • Understand your local laws permitting the use of electric scooters.
  • Never ride your scooter in conditions of poor visibility.
  • Do not do stunts, wheelies or They will increase your chances of injury and damage your LAOTIE ES19.
  • Never carry passengers

Display Manual

LAOTIE Electric Scooter - display

ON/OFF:

Long press the “Power” button for 3 seconds to start or shut down the scooter. Auto OFF: After five minutes of non-using any function, the scooter will be automatically powered off.

Display content switch:

In power-on condition, short press the “Power” Button to switch TRIP/ODO/VOL on the LCD display.
Note: TRIP is Single mileage, ODO is cumulative mileage, VOL is battery voltage.
Speed Mode Switch: In power-on condition, short press the “Mode” Button to switch speed mode.

Parameters Settings:

Enter/Exit Settings Interface: Long press the “Mode” &“Power Button together for 3 seconds.
P00-P09 Switch: Short press the “Mode” button to switch code number Value Adjustment: Short press the “Mode” or “Power” button to adjust.

Code Number Meaning Detail
P00 Wheel diameter setting Programmed by the controller, not available.
P01 Under-voltage setting The standard Parameter should be 50.5 for the LAOTIE ES19 electric scooter.
Not recommend changing.
P02 Number of pole pairs setting Programmed by the controller, not available.
P03 Speed signal selection setting Programmed by the controller, not available.
P04 KM/ Mile selection setting 0 is Km, and 1 is Mile.
P05 Non-zero and zero start selection Programmed by the controller, not available.

 

P06 Cruise and Non-cruise selection 0 is Non-cruise, and 1 is Cruise.
P07 Soft start and hard start selection This P07 setting has been programmed by the controller, not changeable.
P08 Speed limit adjustment If we want to reduce the top speed, we can press the “Power” or “Mode” button to Decrease or increase the percentage number. (For example, if we want 50% of the top speed, we can reduce the percentage number to be 500/o)
P09 EBS brake strength adjustment Programmed by the controller, not available.

Specification

Items Specifications
Brand LAOTIE
Model ES19
Motor Dual 3000W (Peek power) Motors
Battery 60V38.4Ah Lithium Battery
Tire 10×4.5inch Ultra-wide Tires
Controller 45A Controller * 2

 

Brake Front and Rear ZOOM Oil Brake & EABS
Steering Damper 6061 Aluminum Alloy Steering Damper
Max Speed 100 km/h
Max Range Dual Motor 60-70 km, Single Motor 135 km
Climbing Angle 50O
Max Load 200KG
Gross Weight 52KG
Body Size 130x126x28cm
Folding Size 127x51x28cm
Package Size 137x36x57cm

Maintenance

Cleaning and storage

If you see stains on the scooter’s body, wipe them off with a damp cloth. If the stains won’t scrub off, put on some toothpaste, and brush them with a toothbrush, then wipe them off with a damp cloth. If you see scratches on plastic parts, use sandpaper or other abrasive materials to polish them.

Notes: do not clean the scooter with alcohol, gasoline, kerosene or other corrosive and volatile chemical solvents to prevent dire damage. Do not wash the scooter with a high-pressure water spray. During cleaning, make sure that the scooter’s turned off, the charging cable is unplugged, and the rubber flap is closed as water leakage may result in electric shock or other major problems. When the scooter’s not in use, keep it indoors where it is dry and cool. Do not put it outdoors for a long time. Excessive sunlight, overheating and overcooling accelerate tire aging and compromise the scooter and the battery pack’s lifespan.

Battery maintenance

  1. Use original battery packs, use of other models or brands may bring about safety issues;
  2. Do not touch the contacts. Do not dismantle or puncture the casing. Keep the contacts away from metal objects to prevent short circuits which may result in battery damage or even injuries and deaths;
  3. Use original power adapter to avoid potential damage or fire;
  4. Mishandling of used batteries may do tremendous harm to the To protect the natural environment, please follow local regulations to properly dispose of used batteries.
  5. After every use, fully charge the battery to prolong its lifespin.

Do not place the battery in an environment where the ambient temperature is higher than 50°C or lower than -20°C (e.g., do not leave the scooter or the battery pack in a car under direct sunlight for an extended time). Do not throw the battery pack into the fire as it may lead to battery failure, battery overheating, and even another fire. If the scooter is expected to be left idle for more than 30 days, please fully charge the battery and place it in a dry and cool place. Keep in mind to recharge it every 60 days to protect the battery from potential damage which is beyond a limited warranty.

Always charge before exhausting the battery to prolong the battery’s lifespan. The battery pack performs better at normal temperature and is poor when it is below 0°C. For instance, when it is below -20°C, the riding range is only half or less at normal state. When the temperature rises, the riding range restores.

Note: fully charged ES19 Electric Scooter will last for 120-180 days. The built-in intelligent chip will keep a log of its charging and discharging records. The damage caused by prolonged no charge is irreversible and is beyond a limited warranty. Once the damage is done, the battery can not be recharged (non-professionals are forbidden to dismantle the battery pack, as it may cause electric shock, short circuit or even major safety accidents).

Contact Us

Technical support Team: [email protected]

If you have any inquires please feel free to contact us,

we will reply within 24 hours.

LAOTIE Electric Scooter -Qr

https://www.laotie.zone/

Official Store
Scan the code to discover the latest from LAOTIE

Documents / Resources

LAOTIE Electric Scooter [pdf] User Manual
Electric Scooter, ES19

Leave a comment

Your email address will not be published.