Lanteso DBK01 TWS Bluetooth Earbuds USER GUIDE

Lanteso DBK01 TWS Bluetooth Earbuds

PRODUCT OVERVIEW

Ear caps

We provide three sizes of ear caps (large, medium and small). Please use the proper size of ear caps to fit your ears to get a better wearing experience.

Earbuds Manual

Pairing Manual

1. Take out the two earbuds from the charging case and peel off the insulating film.
2. Put the earbuds into the charging case to charge (the earbuds are in charging state).
3. Take out the two earbuds, they will turn on and pair automatically and will be prepared for pairing to the phone (the indicator will turn to Red and blue alternately).
4. After successfully paired the indicator of the right earbud will go off and the indicator of the left earbud will turn to Red and blue alternately.
5. Turn on the Bluetooth function on your phone and search I DBK011 and connect it.

Siri and other Voice Assistants

IoS and part of some Android users can triple-touch the left or right haptic button to turn on the voice assistant.

1. Turn ON
   Take out the earbuds from the charging case or touch the haptic button for 3 seconds until the indicators flash blue once.
2. Turn OFF
   Put the earbuds into the charging case, they would turn off and start charging or disconnect the Bluetooth, it will turn off in about 5 minutes.

How to Reset

1. When the earphone is on with the mobile phone unconnected, press the button four times quickly. Red and blue lights will be on for 2 seconds and it will clear its memory and shut down.
2. Delete the old pairing name and search again on the Bluetooth of the mobile phone.

Charge

Earbuds charging

1. Put the left and right earbuds into the charging case, and the red indicator will turn on.
2. The red light keeps on during charging.
3. The red light turns off after the earbuds are fully charged, and the blue light turns off after a few seconds.

Charging case
Please use an output voltage DC5V/ 1A charger, using a certified USB charger.

Charge warning
while charging, do not press the earbud power button, which will cause pairing failure, then you need to reset.

LED indicatorEarbuds indicator

Button control

Warm notice
For any single earphone, when it is in standalone mode, you can’t use it to play the previous song or decrease the volume.

Specifications

Waterproof

Waterproof for daily life, you cannot submerge earbuds into water. ideal for sweating it out at the gym, or you can wear these earbuds while washing your face, showering, or running in the rain..but not use them while you are diving or swimming.

Signal transmission distance is shown as below:

Attention

1. Please do not use this product while diving as water will block the signal.
2. Do not use corrosive liquid to clean this product.
3. If this product is accidentally exposed to chemicals, clean it with water.
4. Do not use this product under extreme circumstances for temperatures below -10 degree Celsius or above 60 degrees Celsius
5. To avoid an explosion, please do not throw this product into fire.
6. To avoid scratches, please do not touch the earbuds with sharp objects.
7. Do not insert objects into the earbuds, otherwise, it would cause damage to the internal components.
8. Do not disassemble the earbud.
9. Please keep regular charge to earbuds, don’t leave them to become empty battery status to keep their lifetime.
10. Please do not charge products with power adapters over 2A current. Excessive current may cause damage to the battery.

Battery Warning! There is a built-in lithium battery in this product. To avoid explosion, do NOT expose the product to strong sunlight, or fire or throw it into the fire.

FCC Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off  and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

FAQS

VIDEO