FTT iPhone 15 Pro Phone Case

Product Information

Specifications

• Test items: Drop test
• Sample information: Quantity – 1 piece
• Test equipment: Mobile phone-controlled drop test machine
• Laboratory environment: Temperature – 21.3°C, Relative humidity – 58.4%RH
• Testing procedure: Fix the product to the drop test machine, let it fall freely from a height of 0.8m on the granite floor in specified directions

Product Usage Instructions

1. Inspect the appearance and functionality of the product before testing.
2. Fix the product securely to the drop test machine.
3. Ensure the drop test machine is calibrated and the next calibration date is valid.
4. Perform the drop test by letting the product fall freely from a height of 0.8m on the granite floor in specified directions for two test cycles.
5. After testing, check for any abnormalities on the surface of the sample.

Test Report

Address: Floor 4, Building 2, Guanghui Technology Park, No. 13, Minqing Rd, Longhua District, Shenzhen, Guangdong, China (PC: 518109)

• Phone: (+86) 400-6266-018
• Website: http://www.foxtest.cn
• Email: sandy.lm@foxtest.cn

FOXTEST Electrical Engineering And Material Analysis Testing Center

1. Test items:
   Drop test
2. Sample information:
   1. Quantity: 1pcs
   2. Appearance and functionality inspection before testing: OK
3. Test equipment:
   1. Test equipment: Mobile phone controlled drop test machine
   2. Control number: FTT-JS-019
   3. Next calibration date: 2025-02-26
4. Laboratory environment:
   1. Temperature: 21.3℃.
   2. Relative humidity: 58.4%RH.
5. Testing procedure:
   • Testing specifications are provided by the client.
   • Fix the product to the drop test machine, and let it fall freely from a height of 0.8m on the granite floor in specified directions. Two test cycles of drops on the six surfaces and four corners.
   • Dropping order: top – bottom – left – right – front – rear – top-left corner – bottom-left corner – bottom-right corner – top-right corner.
6. Test results:
7. Test photos

Finish

Note

1. If the client has any objection to the test data, the client should submit it to the laboratory within ten days from the date of receipt of the test report. No objection will be accepted after the deadline.
2. This report is invalid without the approver’s signature and the laboratory’s official seal.
3. This test report is only applicable to the samples submitted for testing.
4. Without written approval of the laboratory, no part of this report shall be reproduced.

Frequently Asked Questions

• What should I do if I notice abnormalities on the product after testing?
  If you notice any abnormalities on the product after testing, you should report it to the testing laboratory within ten days from the date of receiving the test report.
• Can I reproduce or distribute this test report without written approval?
  No, reproduction or distribution of this test report is not allowed without written approval from the laboratory.

Documents / Resources

FTT iPhone 15 Pro Phone Case [pdf] Installation Guide iPhone 15 Pro Phone Case, 15 Pro Phone Case, Pro Phone Case, Phone Case

References

• User Manual