DS18-LOGO

DS18 SLG-UDSD6LD-20UP Polaris Slingshot Under Dash Enclosure

DS18-SLG-UDSD6LD-20UP-Polaris-Slingshot-Under-Dash-Enclosure-PRODUCT

POLARIS SLINGSHOT UNDER DASH ENCLOSURE WITH DUAL ZR6.4D SUBWOOFERS INCLUDED

INTRODUCTION

Maximize the BOOM in your Polaris Slingshot with this Passenger Side Under Dash Subwoofer Enclosure by DS18! This enclosure comes loaded with two 6.5” subwoofers underneath your dash to put some BOOM in your Slingshot’s system. They match the factory look of the Polaris Slingshot and are very easy to install using factory bolts location that fit perfectly into place and don’t interfere with your factory glove box.

FEATURES

  • 600 Watts RMS Power Handling.
  • 1200 Watts MAX Power Handling.
  • Two 6.5” ZR6.4D Subwoofers Included.
  • 1 Ohm Total Load Impedance.
  • Easy to install – All Hardware and
  • Wiring Included.
  • OFC 12Ga Wiring, Tinned for More Power Handling and Durability.
  • Fits Slingshot Models from 2020 – to Current.
  • Coated Metal Bracket for Better Resistance to the Elements.
  • Durable (PE) Waterproof Enclosure with UV Protection.
  • 0.3ft3 / 8.5L Sealed Type Enclosure.
  • Damping Material for Better Subwoofers Performance.
  • Black OEM Finish.

WHAT’S IN THE BOX

  • Subwoofer Enclosure with Two ZR6.4D Subwoofers
  • Mounting Bracket
  • 2 x M8 x 1” Screws and Washers
  • 6mm Allen Key

BEFORE BEGINNING INSTALLATION

READ THESE INSTRUCTIONS CAREFULLY

This kit requires an aftermarket amplifier with the speaker wires routed to this location. Following this step, install the speakers. Connect the speakers using the previously installed speaker wires.
Secure the speakers using stainless steel screws and tighten them. Be careful not to over-tighten, as this may damage the hole and prevent the speakers from being properly secured.

INSTALLATION

Open the hood of the Slingshot to gain access to the engine bay. Then, look at the glovebox area on the passenger side. You will see a plane area where the provided bracket will be mounted. (Picture 1)

DS18-SLG-UDSD6LD-20UP-Polaris-Slingshot-Under-Dash-Enclosure-FIG-1

Place the enclosure in the final location under the dash with subwoofer facing down. (Picture 2)

DS18-SLG-UDSD6LD-20UP-Polaris-Slingshot-Under-Dash-Enclosure-FIG-2

Then, use the included M8 screws and washers, insert them from the engine area, down to the box, aligning it with the factory opened holes. For models with the factory ambient lights, remove the LEDs that go into those holes. Using the supplied Allen key, tighten the screws as far as they will go by hand. (Picture 3)

DS18-SLG-UDSD6LD-20UP-Polaris-Slingshot-Under-Dash-Enclosure-FIG-3This concludes the installation of the SLG-UDSD6LD-20UP. Enjoy your new upgrade!

SPECIFICATIONS

  • Speaker Size ……………………………………………………………………………………………….. 2 x 6.5″
  • Total Impedance ……………………………………………………………………………………………..1 Ohms
  • Total RMS Power Handling ………………………………………………………600W
  • Total MAX Power Handling ……………………………………………………1200W
  • Sensitivity (1w/1m) …………………………………………………………………………………..90dB
  • Frequency Response ………………………………………………………………..38Hz-200Hz
  • Recommended Low Pass Crossover ………………………….120Hz

SPEAKER SPECIFICATIONS

  • Voice Coil Diameter ………………………………………………………1.5″ / 38.8mm
  • Voice Coil Former Material ………………….. Aluminum
  • Winding Material ……………………………………………………………………….Copper
  • Cone Material …………………………………………Non-Pressed Paper
  • Dust Cap Material……………………………………………………………………………… PPI
  • Surround Material ……………………………………………………………..Foam
  • Basket Material …………………………………………………………………………….Steel
  • Magnet Material ………………………………………………………………………………Ferrite
  • Magnet Weight ……………………………………………………………………………………………………….50 Oz

ENCLOSURE SPECIFICATIONS

  • Internal Volume …………………………………………………………………………………….. 0.3ft3 / 8.5L
  • Load Configuration ………………………………………………………….. Parallel / Paralelo
  • Enclosure Type …………………………………………………………………………………………. Sealed
  • Enclosure Material ……………………………………….Polyethylene (PE)
  • Finish Material ………………………………………………………………………………. Black
  • 3Db Dropping Point (F3) / Punto de caída -3Db (F3)…………………………………………………………………….42Hz

ENCLOSURE MEASUREMENTS 

  • Overall Height ……………………………………………………………………………………… 7.27″ / 184.66mm
  • Overall Width …………………………………………………………………………………….. 14.64″ / 371.86mm
  • Overall Depth …………………………………………………………………………….. 7.19″ / 182.63mm

MEASUREMENTS

DS18-SLG-UDSD6LD-20UP-Polaris-Slingshot-Under-Dash-Enclosure-FIG-4 DS18-SLG-UDSD6LD-20UP-Polaris-Slingshot-Under-Dash-Enclosure-FIG-5

WARRANTY

  • Please visit our website DS18.com for more information on our warranty policy.
  • We reserve the right to change products and specifications at any time without notice.
  • Images may or may not included optional equipment.

WARNING:
Cancer and Reproductive Harm.
www.P65Warning.ca.gov

DS18-SLG-UDSD6LD-20UP-Polaris-Slingshot-Under-Dash-Enclosure-FIG-6

FOR MORE INFORMATION, PLEASE VISIT DS18.COM

DS18-SLG-UDSD6LD-20UP-Polaris-Slingshot-Under-Dash-Enclosure-FIG-7

Frequently Asked Questions

  • Q: Does the enclosure come with all necessary hardware for installation?
    A: Yes, the enclosure includes all hardware and wiring required for installation.
  • Q: What is the power handling capacity of the subwoofers?
    A: The subwoofers have a RMS power handling of 600 Watts and a MAX power handling of 1200 Watts.

Documents / Resources

DS18 SLG-UDSD6LD-20UP Polaris Slingshot Under Dash Enclosure [pdf] Owner's Manual
SLG-UDSD6LD-20UP, SLG-UDSD6LD-20UP Polaris Slingshot Under Dash Enclosure, Polaris Slingshot Under Dash Enclosure, Slingshot Under Dash Enclosure, Under Dash Enclosure, Enclosure

References

Leave a comment

Your email address will not be published. Required fields are marked *