레이저라이너 - 로고응축 스팟 XP
사용 설명서레이저라이너 콘덴스 스팟 XPLaserliner Condense Spot XP 2

Laserliner Condense Spot XP - icon 2Read the operating instructions and the enclosed brochure „Guarantee and additional notices“ completely. Follow the instructions they contain. Safely keep these documents for future reference.

기능/응용

The CondenseSpot is an infrared temperature measuring instrument with an integrated hygrometer that permits non-contact temperature measurements on surfaces as well as the measurement of relative humidity and ambient temperature. The instrument measures how much electromagnetic energy is emitted in the infrared wavelength range and uses this information to calculate surface temperature. During this process, two additional integrated sensors detect relative humidity and ambient temperature. The dew point is also calculated.

Laserliner Condense Spot XP - figure 1Laserliner Condense Spot XP 3

1 low battery charge 6 min/max and average measurement values
2 stability progress bar for relative
humidity measurement
7 dew point temperature (D Temp) and ambient temperature  (A Temp) in °C or °F
3 laser beam switched on, temperature measurement (infrared) 8 condense water indicator
4 measurements in °C or °F 9 last measurement value will be displayed brie y (7s)
5 relative humidity in % 10 replace battery

Laserliner Condense Spot XP 4Laserliner Condense Spot XP 5

Laser: The laser is a targeting aid to sight the location for the infrared measurement. Only the surface‘s temperature is measured. Laserliner Condense Spot XP 6

7. Displaying Min/Max/Avg, Ambient temperature, Dew point temperatureLaserliner Condense Spot XP 7

8. Dew point temperature is the temperature at which current air conditions would produce condensation. The CondenseSpot calculates the dew point temperature from ambient temperature, relative humidity, and ambient atmospheric pressure. In combination with the infrared thermometer, thermal bridges are easily detected. If the temperature of the measured location drops below the dew point, condensation (water) will form on the surface.Laserliner Condense Spot XP 8

9. 상대 습도
The relative humidity is indicated in relation to the maximum possible humidity (100 %) at which air forms water vapor. The ability of air to hold water is temperature-dependent. Thus humidity is the volume of water vapor in the air. The range for humidity is 0 … 100%. 100% = saturation point.
Under these conditions for temperature and atmospheric pressure, air cannot absorb any more water.Laserliner Condense Spot XP 9

When temperature fluctuations (± 1 °C) and/or changes to relative humidity (± 1%) are rapid, the sensor must adapt itself to the new conditions. An hourglass with a progress bar is displayed during this stabilization process.
During this process, displayed values are only approximations. Only after these symbols have been switched off is a stable value presented which represents maximum accuracy.

10. Setting the emission coef cientLaserliner Condense Spot XP 10

A built-in sensor head detects the material/surface-specific infrared rays emitted by every object. The level of these emissions is determined by the material‘s emission coefficient (0.01 to 0.99). This instrument is preset to an emission coefficient of 0.95, which is applicable to most organic materials as well as plastics,  ceramics, wood, rubber, and stone. For details of those materials with a different emission coefficient, please refer to the table.

알 수 없는 방출 계수:
Apply masking tape or black matt paint to the surface of the area whose temperature you wish to measure. Wait until the tape/paint has heated up.
The temperature of the surface can then be measured with an emission coefficient of 0.95.

11. Emission coef cient tables
비금속

석면 0.93 석회암 0.98
아스팔트 0.95 대리석
Black, dull finish Greyish, polished
0.94
0.93
현무암 0.70
브릭, 레드 0.93
카보 런덤 0.90 콘크리트 공사 0.93
도예 0.95 페인트
블랙, 매트
Heat-resistant White
0.96-0.98 0.92
0.85 - 0.95
중국
Brilliant white With glaze
0.7 - 0.75 0.92
점토 0.95
모든 색상
0.95-0.97
Coal Non-oxidised 0.8-0.9
플라스틱
Translucent PE, P, PVC
0.95
0.94
Concrete, plaster, mortar 0.93
0.77 고무
하드
소프트, 그레이
0.94-0.95 0.89
도기, 매트 0.93
구조 0.95
유리 0.85 - 0.94 석영 유리 0.93
석묵 0.7 - 0.8 0.80
자갈 0.95 0.9 - 0.98
석고 0.8-0.95 타르 0.79 - 0.84
방열판 검정, 양극 산화 처리 0.98 타르 종이 0.91 - 0.93
변압기 페인트 0.94
인간의 피부 0.98 벽지, 밝은 색 0.88-0.90
얼음
지우기
무거운 서리와 함께
0.97
0.98
0.93
목재
미처리
너도밤나무
0.8 -0.95 0.94
라임 0.3 - 0.4
Lime maim brick 0.95

금속

Alloy A3003 Oxidised
거칠게
0.3
0.1 – 03
철, 단조 매트 0.9
리드
거칠게
산화
0.4
0.2 – 0.6
Aluminium Oxidised
우아한
0.2 – 0.4
0.04 – 0.06
Molybdenum Oxidised 0.2 – 0.6
황동
우아한
산화
0.3
0.5
Nickel Oxidised 0.2 – 0.6
플래티넘 블랙 0.9
구리
산화
Elect. terminal strips
0.4 - 0.8 0.6 강철
Cold rolled Ground plate
광택 플레이트
합금(8% 니켈,
18% chromium) Galvanised Oxidised
심하게 산화
Freshly rolled Rough, flat surface
녹슨, 빨강
Sheet, nickel-plated Sheet, rolled
0.7 – 0.9 0.4 – 0.6 0.1
0.35
0.28
0.80
0.88
0.24
0.95- 0.98 0.69
0.11
0.56
Haynes Metal alloy 0.3 – 0.8
인코넬
산화
Sandblasted Electropolished
0.7 – 0.95 0.3 – 0.6 0.15

산화
녹으로
With red rust
0.5년 – 0.9년 0.5년 – 0.7년 0.61년 – 0.85년
철, 주물
산화
Non-oxidised
용융 질량
0.6 - 0.95 0.2
02 – 03
Zinc Oxidised 0.1

기술 자료

Technical revisions reserved. 08.13

Measured quantities °C (°F) infrared temperature measurement, %rH relative humidity, °C (°F) ambient temperature measurement
Infrared measurement range -40 °C … 350 °C (-40 °F … 662 °F)
주위 온도 측정 범위 -10 °C … 60 °C (14 °F … 140 °F)
Relative humidity measurement range 20 % … 90 % rH
Dew point indicator -20°C … 60°C
적외선 정확도 t 1 °C (-10 °C … 60 °C); t 1.5 °C (< 10 °C and > 60 °C) or t 1.5 % whichever value is greater
Ambient temperature accuracy t 2 °C
Relative humidity accuracy t 3 %
Infrared resolution 0.1 ° C
Relative humidity resolution 1%
Dew point resolution 1 ° C
방출 계수 Adjustable, 0.10 … 0.99
작동 온도 0 °C … 40 °C
보관 온도 -20°C … 70°C
광학 8:1 (distance: measured spot)
레이저 파장 650 nm의
레이저 유형 Class 2, < 1 mW
전원 공급 장치 Type 9 V E block battery

General safety instructions.
Attention: Do not look directly into the laser beam! The laser may not get into the hands of children! Do not point this device unnecessarily toward persons.Laserliner Condense Spot XP - warning

EU 지침 및 폐기
Laserliner Condense Spot XP - ce
이 장치는 EU 내에서 상품의 자유로운 이동에 필요한 모든 표준을 준수합니다.
이 제품은 전기 장치이며 폐 전기 및 전자 장비에 대한 유럽 지침에 따라 폐기를 위해 별도로 수거해야 합니다.
추가 안전 및 추가 공지: www.laserliner.com/info
CondenseSpotLaserliner Condense Spot XP - CondenseSpot

Laserliner Condense Spot XP - icon서비스
Umarex GmbH & Co KG
– 레이저라이너 –
Möhnestraße 149, 59755 Arnsberg, 독일
전화: +49 2932 638-300, 팩스: +49 2932 638-333
[이메일 보호]
Umarex GmbH & Co KG
도너펠트 2
59757 독일 안스베르크
전화: +49 2932 638-300, 팩스: -333
www.laserliner.com
레이저라이너 - 로고Laserliner Condense Spot XP - ce

문서 / 리소스

레이저라이너 콘덴스 스팟 XP [pdf] 사용 설명서
응축 스팟 XP

코멘트를 남겨주세요

귀하의 이메일 주소는 공개되지 않습니다.