GCBIG
MD026 True Wireless Earbuds User Guide
진정한 무선 스테레오 이어폰
제품 내용
측정기 사양
블루투스 버전 : 5.3
지원 : HSP / HFP / A2DP / AVRCP
충전 포트 : Type-C
Battery capacity: Earbuds:25mAh
Battery life: 5 hours of use per full charge (actual battery life varies with song type and volume requirements)
Charging time: 1 hour for earbuds / 1 hour for charging case
Transmission range: 15 meters (without obstacles)
소개
How do I pair two headphones with my phone?
- Please make sure both the earbuds and the charging case are fully charged before first use.
- 1단계
Take both earbuds out of the charging case and both earbuds will power on and start pairing automatically (If the earbuds are not connected to your device for more than 5 minutes, the earbuds will automatically turn off Press the MPS button for about 3 seconds to manually turn on the earbuds when prompted “Power on”.) The indicator light of one earbud will flash red and blue alternately, and the indicator light of the other earbud will slowly flash blue when paired successfully. - 2단계
Enable the Bluetooth pairing mode on your phone device, search and select “MD026” to connect. (You should hear a voice prompt “connected” when wearing earbuds). - 이어버드의 표시등이 꺼져 있으면 전화가 연결된 것입니다.
- Automatic connection By default, the earbuds will connect to the last paired mobile automatically when powered on.
- 신속한
- If you have any problem pairing the two earbuds with your phone, put the earbuds back in the charging case and repeat the above steps.
- These earbuds can be used not only together, but also individually
If you want to use a single earbud
Just take one earbud out of the case and connect it to your phone. or when using two earbuds, manually turn off one earbud or put one back in the charging case and you’ll be able to use the other earbud alone.
기능
- 전화 통신
Answer call: Tap once
Hang up: Press and hold the key for 2s
Refuse incoming calls: Press and hold the key for 2s
- 음악을 위해
| 재생 / 일시 중지 | 두 번 탭 |
| 이전 트랙 | "L"을 2초 동안 길게 누릅니다. |
| 다음 트랙 | Press and hold “R” for 2s |
| Siri 활성화 | Quick tap three times |
| 볼륨 낮추기 | A single tap on the left earbud |
| 볼륨 높이기 | A single tap on the right earbud |
충전
- 이어 버드 충전
The earbuds will only be charged when you correctly place them in the charging slots and close the lid. (You can charge the charging case and the earbuds at the same time, or you can charge the charging case first and then the earbuds.)
충전 케이스는 자동으로 충전을 중지하고 완전히 충전되면 이어버드의 표시등이 꺼집니다.
When the earbuds are charging in the charging case, the digital display bar of the case will keep blinking and turn off after 60 seconds. - 케이스 충전
There is a Type-C usb charging cable in the package, please use it to charge the case directly. During charging, the digital display will flash and display the battery level in real-time. When fully charged, the number shows 100.
충전 경고 
- After using it for a long period of time, due to the oxidation of the magnet connector, the earbuds might not be charged or even turned on. You can fix this problem by cleaning the magnet connectors on the earbuds and charging case with an alcohol wipe
- Put the earbuds in the charging case, and the earbuds will turn off immediately and the charging case will start charging automatically. The earbuds will connect to the last paired mobile automatically.
보관 및 유지 관리
- If the earbuds have not been used for more than 3 months, we recommend that you charge them.
- Please use a charger approved by FCC FFC : (Federal Communications Commission).
- Do not disassemble the earbuds.
- 12세 이하의 어린이는 성인의 감독이 필요합니다.
- 이어버드를 고온 또는 저온에 노출시키지 마시고, 천둥 번개가 칠 때 이어버드를 사용하지 마세요.
- 기기에 자유낙하나 심한 충격을 주지 마십시오. 장치를 화기에서 멀리하고 장치를 물에 넣지 마십시오.
자주 묻는 질문
Q: Why don’t these earbuds pair with my phone?
A: Make sure the earbuds are fully charged and powered on. Make sure your phone’s Bluetooth is enabled If there is no problem with the two points stated above, turn off the powered-on earbuds after 5 continuous and quick clicks. Put them back into the charging case and close the lip, wait for 1 minute, then open the charging case and reconnect the earbuds to the phone.
Q: Why does the music cut in or out?
A: First, keep the earbuds no more than 49 feet away from your phone (no obstacles). If the distance is less than 49 feet, follow these steps:
- Put the earbuds back into the case and close the lid, manually click “forget the MD026” on your phone
- 10초 후 충전 케이스를 열고 이 이어버드를 휴대폰에 다시 연결합니다.
Q: Why do the earbuds still won’t be charged or disconnected from the phone after I put them in the case and close the lid?
A: Make sure the charging case is not in a low battery state. If the charging case is in a low battery state, the earbuds will neither be charged nor disconnected. In this case, please use a type-c charging cable to fully charge the case.
Q: Are these earbuds sweat- and water-resistant?
A: These earbuds are sweatproof and slightly waterproof. For electronic devices, we do not recommend that you submerge the earbuds in water.
For more detailed product FAQs, please contact our customer service.
Activation & Warranty
Permanent replacement of damaged, defective, upgraded, or missing items (no need to return the original)
Please activate via email below within 15 days. ” [이메일 보호]"
문서 / 리소스
 |
GCBIG MD026 True Wireless Earbuds [pdf] 사용 설명서 MD026 True Wireless Earbuds, MD026, True Wireless Earbuds |
