1. 서론
This manual provides essential information for the safe and effective use of your glo HYPER+ heated tobacco device. The glo HYPER+ offers a versatile experience with both normal and high-temperature modes, allowing for personalized usage. Please read this manual thoroughly before using the device.
중요 참고 사항: This product includes the electronic tobacco device only. It does not contain liquid or nicotine, nor does it include tobacco sticks (neostiks).
2. 패키지 내용
Verify that all items listed below are included in your package. According to the product packaging, the contents are:
- glo HYPER+ Device (Main Unit)
- USB 충전 케이블
- 청소용 브러시
- 사용 설명서(본 문서)
Note: Tobacco sticks (e.g., neostiks) are not included and must be purchased separately.
Image: The glo HYPER+ Starter Kit packaging, indicating the included items.
3. 설정
3.1 초기 충전
- Connect the provided USB charging cable to the charging port on the bottom of the glo HYPER+ device.
- USB 케이블의 다른 쪽 끝을 호환되는 USB 전원 어댑터(포함되지 않음)나 컴퓨터의 USB 포트에 꽂습니다.
- The LED indicator lights on the device will illuminate to show the charging status. A full charge typically takes approximately 90 minutes.
- Once fully charged, all LED indicators will be solid. Disconnect the device from the charger.
메모: For optimal battery life, it is recommended to fully charge the device before its first use.
4. 사용 설명서
4.1 Inserting a Tobacco Stick
- Open the top cap of the glo HYPER+ device.
- Gently insert a compatible tobacco stick into the heating chamber until it reaches the bottom. Do not force the stick.
- Close the top cap.
4.2 전원 켜기 및 가열
The glo HYPER+ offers two heating modes: Standard and Boost.
- 표준 모드: Press and hold the control button for approximately 3 seconds until the device vibrates and the LED indicators begin to light up sequentially. The device will heat for about 20 seconds.
- Boost Mode (High Temperature): Press and hold the control button for approximately 5 seconds until the device vibrates twice and the LED indicators light up more rapidly. The device will heat for about 15 seconds, providing a more intense experience.
Once heating is complete, the device will vibrate again, and the LED indicators will remain solid, indicating it is ready for use.
4.3 장치 사용
Inhale gently through the tobacco stick. Each session lasts approximately 4 minutes in Standard mode and 3 minutes in Boost mode, or until the device vibrates and the LED indicators turn off.
4.4 Ending a Session
- When the session ends, the device will vibrate, and the LED indicators will turn off.
- Open the top cap and carefully remove the used tobacco stick. Dispose of it properly.
- Close the top cap to prevent debris from entering the heating chamber.
이미지: 클로즈업 view of the glo HYPER+ device, highlighting its design and control button.
5. 유지관리
Regular cleaning ensures optimal performance and longevity of your glo HYPER+ device.
5.1 Cleaning the Heating Chamber
- Ensure the device is completely cooled down before cleaning.
- Open both the top and bottom caps of the device.
- Insert the provided cleaning brush into the heating chamber from both ends (top and bottom) and gently rotate it to remove any residue.
- Tap the device gently to dislodge any loose debris.
- Close both caps after cleaning.
추천: Clean your device after every 20 sessions or as needed to maintain optimal flavor and airflow.
6. 문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 장치가 켜지지 않습니다. | 배터리가 부족합니다. | 제공된 USB 케이블을 사용하여 장치를 충전하십시오. |
| 증기 발생이 없거나 매우 약합니다. | Incorrectly inserted tobacco stick, device not fully heated, or dirty heating chamber. | Ensure the tobacco stick is fully inserted. Wait for the device to complete heating. Clean the heating chamber. |
| 장치가 충전되지 않습니다. | 케이블 또는 전원 공급 장치에 문제가 있습니다. | 다른 USB 케이블이나 전원 어댑터를 사용해 보세요. 연결이 제대로 되었는지 확인하세요. |
| 장치가 과열되었습니다. | Continuous use or environmental factors. | Allow the device to cool down. Avoid using in direct sunlight or hot environments. If the issue persists, discontinue use and contact support. |
If you encounter issues not listed here or if the problem persists after attempting the solutions, please contact customer support.
7. 사양
- 모델: HYPER+
- 상표: 글로
- 치수(포장): 11.1 x 8.6 x 7.2cm
- 포장 중량: 310g
- 색상: 금
- 포함된 구성 요소: Main unit, USB charging cable, cleaning brush, instruction manual
- 난방 모드: Standard, Boost (High Temperature)
- 첫 번째 가능한 날짜: 2021/11/23
8. 보증 및 지원
For warranty information, product support, or to report any issues, please refer to the official glo web사이트를 방문하거나 고객 서비스에 직접 문의하세요. 보증 청구를 위해 구매 증빙 자료를 보관하세요.
