Manual and Warranty
Folded 105 x 150 mm
File name: 5060_MAN_IE_42829591, 42829614, 42829621, 42829669_TWS D Fast Slimline_v5
Artwork Proof Date: 9.12.19
Number of artboards: 1
Please use 200gsm bright white UNCOATED paper
Print Colours: Single colour black
Do Not Print: Dieline, Info
Flat Size: 105 x 148 mm
ARTWORK SHOULD NOT BE AMENDED WITHOUT PRIOR AGREEMENT FROM CREST. ALL ARTWORK MUST BE APPROVED BY CREST PRIOR TO MASS PRODUCTION.
IF THERE ARE QUERIES ABOUT THIS ARTWORK PLEASE CONTACT:
EMAIL: [email protected]
© The Crest Company 2019. All rights reserved.
CHANGE LOG CREST INTERNAL USE ONLY
Charging Case power button
How to use these earphones:
Earphone Function Operation
Pause Press either 0 button
Play Press either 0 button
Next Track Press and hold the right 0 button for 3 seconds
Previous Track Press and hold the left 0 button for 3 seconds
Press either 0 button
Press and hold either 0 button
Press either 0 button
Press and hold 0 button (on each Earphone) for 3 seconds
Press and hold 0 button (on each Earphone) for 8 seconds
Activating Phone Assistant
Press either 0 button 3 times in quick successions
Volume Up Press the right 0 button 2 times in quick successions
Volume Down Press the left 0 button 2 times in quick successions
Pairing the Earphones with Bluetooth® devices
» Go to “Bluetooth” Settings on your Bluetooth device (phone, tablet, etc.).
» Turn the Bluetooth ON, on your device.
» Press the charging case power button, make sure the Earphones are in charging status. Open the charging case and remove the Earphones, they will automatically turn on (or they can be turned on manually). The LED indicators on the left and right Earphones will flash blue and red as they automatically sync to each other. Once synced the Earphones will enter pairing mode, which is identifiable by one Earphone LED going out while the other continues to flash Blue and Red.
» On your Bluetooth Device, select the pairing name of your Earphones on the list of available devices.
White – KM42829591
Champagne – KM42829614
Blush – KM42829621
Black – KM42829669
The Earphone LED will stop flashing Blue and Red once connected.
» You are now connected.
(Trouble shooting tip: if the Earphones do not connect to your device, turn the Earphones OFF, turn your device’s Bluetooth OFF and then back ON, then repeat the pairing process).
» Your anko TWS Earphones will be synced together already when you first open the pack, however if they are ever disconnected please follow the below instructions to pair them again.
- Take out both earphones from the case (or turn on manually).
- Both Earphone’s LED will flash blue and red.
- After 5-7 seconds, only one Earphone’s LED will flash blue and red, which indicates that the Earphones have now been synced and is again ready to pair to your device.
If there is an incoming call on your Bluetooth device, the Earphones will pause any playback and ring to alert you of the call. To answer the call, press either Earphone button. To end a call, press either Earphone button again.
Charging the Case
» Connect the Micro USB charging cable into the socket on the Charging Case.
» Plug the cable into a standard USB 5V/1A output.
» The case LED indicator will flash Blue while the case is charging and will stay on when fully charged.
» When fully charged, unplug the charging cable.
Warning: To avoid damage to the Charging Case, please only use a 5V/1A charger.
Charging the Earphones
» Put the Earphones into the Charging Case, ensuring that the charging prongs make full contact.
» The Earphone LED indicator will stay red while charging. When charging is complete the LED will turn off completely.
(Before using the Earphones for the first time, we recommend you fully charge the battery. A full charge takes around 1 hour).
In order to ensure the battery life, the Earphones and Charging Case should be charged normally once a month.
WARNING: The Earphones can be used with the provided Charging Case only.
5.0 Bluetooth chipset
A2DP, AVRCP, HFP
Battery capacity (Charging Case):
Charge time (Charging Case):
Battery capacity (Earphones):
2 x 25mAh
Charge time (Earphones):
1 Hour approx
Pairing window time:
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth® SIG. Inc. and any use of such marks by KMART AUSTRALIA is under licence.
WARNING Do not dispose of unit in fire or water. ) Never attempt to disassemble and reassemble. ) Waste electrical products should not be disposed of with household waste, please recycle where facilities exist. ) Check with your local authority for recycle advice.) Keep your device and all accessories out of the reach of children and animals. ) Small parts may cause choking or serious injury if swallowed. ) Avoid exposing your device to very cold or very hot temperatures (below 0°C or above 45°C). ) Extreme temperatures can cause deforming of the device and reduce the charging capacity and life of your device. ) Do not allow your device to get wet—liquids can cause serious damage. ) Do not handle your device with wet hands.
12 month warranty
Thank you for your purchase from Kmart.
Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with the accompanying recommendations or instructions where provided. This warranty is in addition to your rights under the Australian Consumer Law.
Kmart will provide you with your choice of a refund, repair or exchange (where possible) for this product if it becomes defective within the warranty period. Kmart will bear the reasonable expense of claiming the warranty. This warranty will no longer apply where the defect is a result of alteration, accident, misuse, abuse or neglect.
Please retain your receipt as proof of purchase and contact our Customer Service Centre on 1800 124 125 (Australia) or 0800 945 995 (New Zealand) or alternatively, via Customer Help at kmart.com.au for any difficulties with your product. Warranty claims and claims for expense incurred in returning this product can be addressed to our Customer Service Centre at 690 Springvale Rd, Mulgrave Vic 3170.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
For New Zealand customers, this warranty is in addition to statutory rights observed under New Zealand legislation.
True Wireless Earphones
- true wireless earphones
- charging case
- charging cable (micro USB cable)
42-829-591 Bluetooth name is KM42829591
42-829-614 Bluetooth name is KM42829614
42-829-621 Bluetooth name is KM42829621
42-829-669 Bluetooth name is KM42829669