សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 08 ខែតុលា ឆ្នាំ 2025 - ម៉ោង 10:28 ព្រឹក
**Continuity Test Procedure:**
1. **Select Continuity Mode:**
- Short press the ប៊ូតុង SEL to select the continuity gear (symbol: \()).
2. **Probe Connection:**
- Plug the black probe into the COM port and the red probe into the INPUT port.
3. **Circuit Connection:**
- Connect the red and black probes to the circuit under test.
4. ** ការធ្វើតេស្ត៖ **
- When the resistance value of the tested circuit is less than about 302, the multimeter will emit continuous sounds.
5. **ការបញ្ចប់៖**
- Once the continuity test is done, you can exit the mode by short pressing the HOLD button or proceed to other measurement functions.
** ចំណាំបន្ថែម៖ **
- Ensure the probes are securely connected to the correct ports for accurate readings.
- The continuity test helps determine if a circuit is complete or if there is a break in the connection.
- The multimeter's buzzer will sound continuously when continuity is detected, indicating a complete circuit path.
For further details or troubleshooting, refer to the MESTEK M101050205 Smart Digital Multimeter សៀវភៅណែនាំអ្នកប្រើប្រាស់។
បន្ថែមមតិយោបល់ថ្មី។