សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 05 ខែតុលា ឆ្នាំ 2025 - ម៉ោង 09:18 ព្រឹក
Setting up the EDID and Smart Scale settings on the BLUSTREAM SP12CS HDMI Splitter is crucial for ensuring compatibility and optimal performance. Here's a step-by-step guide based on the information provided in the user manual:
**EDID Configuration:**
1. Locate the EDID DIP switches on the rear panel of the splitter.
2. Use the provided chart to select the desired EDID setting based on your source device and display capabilities.
3. Set the DIP switches to the corresponding binary code for the desired EDID setting.
4. You can choose between various HDMI resolutions, HDR options, and audio formats by adjusting the DIP switches accordingly.
**Smart Scale Configuration:**
1. Find the Smart Scale DIP switches on the rear panel of the splitter.
2. By default, the Smart Scale mode is set to AUTO (both switches pointing UP) for automatic negotiation of the best output resolution.
3. If you need to force a specific resolution (e.g., 1080p) on individual outputs, you can change the Smart Scale mode.
4. To force a specific resolution, follow the sequence: 00 > 10 > 00 > 10 > 00 > 10 > 00 for the left switch (HDMI Output 1).
5. After completing the sequence, the input LEDs will flash. Set the Smart Scale DIP switch to 'DOWN' for the desired output to be fixed at 1080p.
6. To revert the setting, simply switch the DIP switch back to the UP position.
By following these steps, you can customize the EDID and Smart Scale settings on the BLUSTREAM SP12CS HDMI Splitter to suit your specific setup and requirements.
បន្ថែមមតិយោបល់ថ្មី។