សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 03 ខែតុលា ឆ្នាំ 2025 - ម៉ោង 02:42 យប់
ដើម្បីកំណត់ឡើងវិញ Eltako ESR62PF-IP-110-240V Impulse Switch with Relay Function IP to its factory settings, you can follow the steps outlined in the manual:
1. **Factory Reset via Eltako Connect App:**
- Use the Eltako Connect app to initiate the factory reset process.
- Follow the instructions provided in the app to reset the device.
2. **Factory Reset via Supply Voltage:**
- Apply supply voltage to the device (within a 5-minute time window).
- Press the connected switch/button 8 times briefly (<1 sec.) and 1 time long (>1.5 sec. and <5 sec.).
- A signal tone will sound for the last two short closing actions, confirming the reset.
- If the actions are not performed within the time window, the device will simply restart.
3. **Factory Reset via Disconnection and Reconnection:**
- Disconnect the device from the supply voltage.
- Apply supply voltage, wait for the signal tone, and then disconnect the supply voltage ក្នុងរយៈពេល 5 វិនាទី។
- Repeat the previous step a total of 5 times.
- On the sixth time the supply voltage is switched on, the successful factory reset will be confirmed by 3 short and 3 long beeps.
It is important to note that after a successful reset, the device will restart and may require reconfiguration. Always refer to the manual for detailed instructions and safety precautions when performing a factory reset on the Eltako ESR62PF-IP-110-240V Impulse Switch with Relay Function IP.
បន្ថែមមតិយោបល់ថ្មី។