សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 03 ខែតុលា ឆ្នាំ 2025 - ម៉ោង 02:16 យប់
ដើម្បីសាកល្បង ឧបករណ៍ចាប់ភ្លើងឥតខ្សែ FireProtect 2 RB Jewelerអនុវត្តតាមជំហានទាំងនេះ៖
1. **Using the Test/Mute Button:**
- Press the central part of the front panel of the detector lightly for 1.5 seconds to initiate the self-test.
- During the test, the red LED will blink five times rapidly, followed by three slower blinks. The siren will beep in sync with the LED indication.
- After the test, you will receive a notification of the detector's state in the Ajax app, and the detector will indicate the test result with sound and LED indications.
2. **Using the Ajax App:**
- Open the Ajax app and select the hub.
- Go to the Devices menu and choose FireProtect 2 (Heat/Smoke).
- Access the settings by clicking on the gear icon.
- Click on the Device Self-test field to run the test.
- Follow the on-screen instructions to complete the test.
3. **Interpreting Test Results:**
- If the test fails and a malfunction is detected, the detector will indicate this by blinking the yellow LED twice and beeping twice in sync with the LED.
- If there are no sound and LED indications during the self-test, contact Ajax Technical Support for assistance.
4. **Additional Testing:**
- The Ajax security system provides a Jeweller Signal Strength Test to determine the signal strength at the installation location. This test helps ensure stable operation of the detector.
- Perform the Jeweller Signal Strength Test as described in the manual to verify the signal strength between the detector and the hub or range extender.
By following these steps, you can test the ឧបករណ៍ចាប់ភ្លើងឥតខ្សែ FireProtect 2 RB Jeweler to ensure it is functioning correctly and ready to detect smoke and temperature rise effectively.
បន្ថែមមតិយោបល់ថ្មី។