សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 03 ខែតុលា ឆ្នាំ 2025 - ម៉ោង 01:35 យប់
ដើម្បីម៉ោន UNITRONICS V120 Rugged Programmable Logic Controller, you can follow these steps as outlined in the user guide:
**Panel Mounting:**
1. Ensure that the mounting panel is not more than 5 mm thick.
2. Make a panel cut-out of the appropriate size (92x92 mm for the V120 model).
3. Slide the controller into the cut-out, ensuring that the rubber seal is in place.
4. Push the mounting brackets into their slots on the sides of the panel.
5. Tighten the bracket’s screws against the panel, holding the bracket securely against the unit while tightening the xxxx .
6. Once properly mounted, the controller should be squarely situated in the panel cut-out.
**DIN-rail Mounting:**
1. Snap the controller onto the DIN rail.
2. Ensure that the controller is squarely situated on the DIN rail.
By following these mounting instructions, you can securely install the UNITRONICS V120 Rugged Programmable Logic Controller either on a panel or a DIN rail for efficient operation. For more detailed information, you can refer to the user guide provided by UNITRONICS or visit their technical library on their webគេហទំព័រ។
បន្ថែមមតិយោបល់ថ្មី។