សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 02 ខែតុលា ឆ្នាំ 2025 - ម៉ោង 02:40 យប់
To access and configure the LANCOM GS-3652XP កុងតាក់ចូលគ្រប់គ្រងពេញលេញ, follow these steps based on the provided user guide:
1. **Configuration Interface (Console):** Connect the configuration interface using the included serial configuration cable to the serial interface of the switch. This interface is used for configuring and monitoring the switch.
2. **TP Ethernet Interfaces:** Use Ethernet cables to connect interfaces 1 to 48 to your PC or a LAN switch. This allows you to establish connections for your network devices.
3. **SFP+ Interfaces:** Insert LANCOM SFP modules into interfaces 49 to 52. Ensure compatibility with the SFP modules and follow the connection instructions provided in the module's documentation.
4. **Power Connector:** Supply power to the device via the power connector located on the back side of the switch. Use the provided IEC power cable or a country-specific LANCOM Power Cord for power connection.
5. **Attention:** Before connecting the power supply, ensure to connect to earth to prevent high touch current. This is important for safety during the power setup.
6. **Open-Source Software Components:** The product contains separate open-source software components with their own licenses, such as the General Public License (GPL). You can find license information for the device firmware (LCOS) on the device's WEBconfig interface under "Extras > License information."
7. **Compliance:** LANCOM Systems GmbH declares that the device is in compliance with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU, and Regulation (EC) No. 1907/2006. The EU Declaration of Conformity can be accessed on LANCOM's webគេហទំព័រ។
By following these steps and guidelines from the user guide, you can effectively access and configure the LANCOM GS-3652XP កុងតាក់ចូលគ្រប់គ្រងពេញលេញ for your networking needs.
បន្ថែមមតិយោបល់ថ្មី។