សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 02 ខែតុលា ឆ្នាំ 2025 - ម៉ោង 01:52 យប់
ដើម្បីដំឡើង Waterway SGMS Micro Air Injector using SGMS Technology, follow these steps:
1. **រៀបចំតំបន់ដំឡើង៖**
- Choose a suitable location for installing the air injector. Ensure there is enough space and access for the installation process.
2. **Drill the Hole:**
- Use a 43/64" diameter hole saw to create the necessary hole for the air injector. Make sure the hole is clean and free from any debris.
3. **Insert the Air Injector:**
- Insert the SGMS Micro Air Injector into the hole you drilled. Ensure it fits securely and is properly aligned.
4. **Plumb the Air Injector:**
- Connect the air injector using 3/8" tubing. Use the provided adaptors (such as the 3/8" SB Straight Adaptor and 3/8" SB Micro 90° Ell Adaptor) to facilitate the plumbing process.
5. **Secure the Air Injector:**
- Ensure the air injector is securely in place and properly sealed. Use EPDM grommets to provide a watertight seal.
6. **Optional LED Installation (if applicable):**
- If you have the LED version of the air injector, follow the manufacturer's instructions for installing the LED probe (such as the 1" Micro Water Feature Wye 30° LED Probe).
7. **Test the Installation:**
- Once the air injector is installed, test it to ensure proper functionality. Check for any leaks or issues with the air injection process.
By following these steps and referring to the provided manual, you should be able to successfully install the Waterway SGMS Micro Air Injector using SGMS Technology. If you encounter any difficulties during the installation process, consult the manual or contact Waterway Plastics for further assistance.
បន្ថែមមតិយោបល់ថ្មី។