សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 02 ខែតុលា ឆ្នាំ 2025 - ម៉ោង 09:22 ព្រឹក
To properly set up and assemble your Clearaudio Statement V2 Turntable, follow these step-by-step instructions as outlined in the user manual:
1. **Positioning the Turntable Base:**
- Place the Statement V2 turntable base on the four supplied feet in the desired location.
2. **Assembling the Pendulum:**
- Slide the solid metal discs over the pendulum shaft, ensuring a felt mat is placed between each disc.
- Build the pendulum with three solid discs at the bottom, followed by six half-cut-away discs, then two solid discs, and finally add the disc engraved with "Clearaudio Statement V2."
3. **Placing Cork Damping Plates:**
- Place the four cork dampការដាក់ចាននៅលើកំពូលនៃសសរជ្រុងទាំងបួន។
4. **Installing the Stainless Steel Cross Frame:**
- Lower the stainless steel cross frame over the pendulum shaft, ensuring it rests on the cork dampចាន។
- Tighten the bearing to the shaft by tightening the screws in the bearing collar.
5. **Locking the Gimbal Bearing:**
- Lift the pendulum shaft to align the V-shaped groove in the pendulum shaft with the locking screws in the gimbal bearing.
- Lock the gimbal bearing to the pendulum shaft by fully tightening the eight screws.
6. **Attaching the Floating Chassis:**
- Lift the whole upper section, raise the pendulum off the wooden blocks, and carefully lower it back onto the cork dampចាន។
- Lock the floating chassis to the pendulum shaft by fully tightening the eight screws.
7. **Assembling the Main Components:**
- Lower the main floating chassis over the top of the pendulum shaft.
- Apply Clearaudio Synthetic Bearing Oil to the bearing spindle.
- Place the lower drive bearing housing over the bearing spindle and the lower magnetic drive platter over the bearing housing.
8. **Completing the Assembly:**
- Insert the bearing spindle into the bearing sleeve in the acrylic chassis.
- Attach the upper drive platter to the bottom of the main bearing spindle and ensure proper alignment.
- Lower the acrylic chassis onto the four pillars at the corners of the floating chassis and firmly xxxx the stainless steel arm bases.
9. **Motor Adjustment and Final Steps:**
- Push the motor pulley over the motor spindle and place the drive belt around the lower drive platter and motor pulley.
- Plug the power supply into the motor and mains supply.
- Refer to the tonearm manufacturer's manual for tonearm assembly.
By following these detailed assembly instructions, you can ensure that your Clearaudio Statement V2 Turntable is set up correctly for optimal performance and enjoyment of your music.
បន្ថែមមតិយោបល់ថ្មី។