សៀវភៅណែនាំអ្នកប្រើប្រាស់ សំណួរ និងចម្លើយចម្លើយ
ថ្ងៃទី 01 ខែតុលា ឆ្នាំ 2025 - ម៉ោង 02:01 យប់
To install and configure the for optimal performance, follow these steps as outlined in the user manual:
1. **Location Selection:**
- Choose a location that complies with the manual requirements.
- Ensure the detector lens is perpendicular to the intended path of entry.
- Avoid obstructing the field of view with furniture or glass structures.
- Avoid direct sunlight, rapidly changing temperature sources, and fast air circulation.
2. **Installation and Connection:**
- Switch off the control panel and disconnect the hub's power supply.
- Route the cable into the hub and connect the wires to the bus terminals.
- Remove the SmartBracket mounting panel from the detector and route the wire into the detector enclosure.
- Connect the wires to the terminals according to the diagram provided in the manual.
- Perform a Fibra signal strength test to ensure a stable connection.
3. **Adding to the System:**
- Ensure the hub is turned on and connected to the internet.
- Open the AJAX PRO app, select the hub, and go to the Devices tab.
- Add the MotionCam Fibra manually by naming it, scanning the QR code, and selecting a room and group.
- Perform the Fibra signal strength test and Detection zone test to ensure proper functionality.
4. ** ការថែទាំ៖ **
- Regularly check the functioning of the detector and clean it from dust and contaminants using a soft dry cloth.
- Avoid using substances containing active solvents for cleaning to prevent damage to the detector.
By following these installation and configuration steps as outlined in the user manual, you can ensure optimal performance of the AJAX Fibra MotionCam detector in your security system.
បន្ថែមមតិយោបល់ថ្មី។